Abstract:The uniformity of the cell size of aluminum foams prepared by traditional melt foaming and gas injection methods is difficult to control. In order to improve the controllability of cell size and mechanical performance of aluminum foam, an A356 matrix syntactic foam was prepared by the improved stir casting process. Moreover, the compressive property of the syntactic foam was studied and compared with other metal foams. Al2O3 hollow spheres with the diameters of 3-5mm were added in the molten A356 alloy, then the syntactic foam can be obtained after stirring and compaction. The hollow spheres in the syntactic foam are random loose packed. The volume fraction of 3-3.5 mm hollow spheres in the syntactic foam could reach to 56%. The total densities of the syntactic foams are around 1.79 g/cm(3). Through the analysis both in macroscopic and microscopic, the interfacial bonding between aluminum matrix and hollow spheres was proved to be good even after mechanical cutting. The quasi-static compression result showed that the plateau stress of the syntactic foam with 3-3.5mm hollow spheres could reach up to 46 MPa, and the corresponding densification strain energy is 20 MJ/m(3). Moreover, the plateau region is flat, long and relatively high. The syntactic foam with the hollow spheres of 3-4 mm diameter has the highest overall porosity and the best compressive performance. Compared with other traditional aluminum foams, this syntactic foam has advantages in energy absorption performance and the adjustability of cell size.

Microstructure and Compressive Properties of Inco-617 Alloy Hollow Sphere Foam

Fabrication and Mechanical Properties of INCO-617 Alloy Hollow Sphere Particles

Fabrication and compressive properties of K405 alloy hollow sphere foams

Factors affecting the microstructure of a fine ceramic foam

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Microstructure and compression behavior of cenosphere filled aluminum syntactic foams

Fabrication and Molding of Low Density Divinylbenzene Foams by ICF

Interface characterization and mechanical property of an aluminum matrix syntactic foam with multi-shelled hollow sphere structure

Microstructure and mechanical properties of bimodal syntactic foams with different size combination and volume fraction of alumina hollow spheres

Pore Structure and Compressive Properties of Open-Cell Aluminum Foams Prepared by Infiltration Casting Based on NaCl Space-Holder

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Preparation and characterization of light weight aluminum matrix syntactic foams with high energy absorbing capacity

Solidification Structure and Sound Absorbability of A356 Alloy Foams

Enhanced compressive properties of additively manufactured hollow sphere materials with novel configurations

Fabrication and Compressive Behavior of Open-Cell Aluminum Foams Via Infiltration Casting Using Spherical CaCl2 Space-Holders

Preparation and characterization of SiC p/2024Al composite foams by powder metallurgy

A Novel Way to Prepare Hollow Sphere Ceramics

Investigation on Fabrication and Microstructure of Ti–6Al–4V Alloy Hollow Spheres by Powder Metallurgy

Effects of Microporosity on the Elasticity and Yielding of Thin-Walled Metallic Hollow Spheres

Microstructural Influence on Compressive Behavior and Strain Rate Sensitivity of Open-Cell Nickel Foam

Microstructure and Strength Correlation of Pure Al and Al-Mg Syntactic Foam Composites Subject to Uniaxial Compression