Abstract:The solidification microstructure of aluminum foams is evidently different from that of bulk aluminum alloys. Generally, a single α-Al grain runs through the entire thickness of a cell-wall, and the grain morphology is irregular. However, the formation mechanism of the special microstructure in aluminum foams is unclear now, and few studies focused on optimizing the microstructure. In this study, grain refinement of aluminum foams by increasing cooling rate and inoculation were carried out, and thermal analysis was used to measure and judge solidification of aluminum foams. Experimental results show that grain refinement can be achieved by the above two methods, and the latter is more effective. The nucleation undercooling of aluminum foams decreases with the increase of Al–5Ti–1B addition. Grains can be well refined even in thin cell walls after inoculation, and the grain morphology changes from irregular to equiaxed. Under the same conditions, α-Al grains of Al foams are smaller than those of the bulk Al alloy, either with or without inoculation. An anisometric growth model of α-Al grains in foamed aluminum melt restricted by surrounding bubbles is proposed. The model shows that: (1) the size of the inhibited nucleation zone (INZ) around growing grains decreases due to the high constitutional undercooling caused by solute enrichment in cell walls, thus grains in cell walls are smaller than those of bulk Al alloy; (2) under normal solidification conditions, the shape of the INZ is irregular. Grains in aluminum foams will replicate contours of cell walls or Plateau borders, presenting irregular shapes. Increasing cooling rates and/or inoculation can reduce the size of INZ and change its shape. The grain morphology will change from irregular to equiaxed under proper conditions.

Solidification Structure and Sound Absorbability of A356 Alloy Foams

Factors affecting the microstructure of a fine ceramic foam

Extrusion Foaming Of Lightweight Polystyrene Composite Foams With Controllable Cellular Structure For Sound Absorption Application

Preparation and Compressive Performance of an A356 Matrix Syntactic Foam

Microstructure and Compressive Properties of Aluminum Foams Made by 6063 Aluminum Alloy and Pure Aluminum

Properties of Aluminum Foam Prepared by Gas Injection Method

Solidification microstructure and grain refinement of closed-cell aluminum foams

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Effect of calcium addition on the aluminum alloy A201 foam

Al and A356 Alloy Foam Castings Modified with Low Concentrations of Nano-Sized Particles: Structural Study and Compressive Strength Tests

Characterization of as-cast microstructure of aluminum foams by melt foaming method

Effect of Cu and Sn Additions on the Cellular Structure of Al–Si–Mg Alloys Foaming at Low Temperature (≤600 °C)

Effect of Heat Treatment on the Microstructure, Compressive Property, and Energy Absorption Response of the Al–Mg–Si Alloy Foams

Enhanced energy absorption and microstructural studies on hollow glass microsphere filled closed cell aluminum matrix syntactic foam

Fabrication of Mg-Al Alloy Foam with Close-Cell Structure by Powder Metallurgy Approach and Its Mechanical Properties

Foamability and mechanical properties of in situ submicron MgAl2O4p/Al composite foams by ultrasonic method

Effects of process parameters and alloy compositions on the pore structure of foamed aluminum

Controllable Design of Structural and Mechanical Behaviors of Al‐Si Foams by Powder Metallurgy Foaming

The influence of pure Al and hypoeutectic Al Si alloy base materials on the cell structures of aluminum foams produced by gas injection foaming process

Research on Key Technologies for Batch Preparation of Aluminum Foam Slabs by Melt Foaming Process

Comparison of Cell Wall Microstructure of Aluminum Foams Produced by Melt Foaming and Gas Injection Foaming Processes