Abstract:Co-substituted LiCo1/6Mn11/6O4 powders were prepared by a spray-drying method for positive electrodes of lithium ion batteries. The heat treating process, crystal structure and electrochemical properties of the synthesized materials were investigated by TG/DTG, DSC, XRD, SEM, slow rate cyclic voltammetry (CV) and galvanostatic charge/discharge cycling tests. The final powders were identified as single-phase spinel LiCo1/6Mn11/6O4 with high degree of crystallization and uniform particle size distribution. In the charge/discharge potential (versus Li/Li+) ranging from 2.0 to 4.4V, the LiCo1/6Mn11/6O4 electrode delivered high initial discharge capacity of 242mAhg−1 at 1/10C rate at 25°C. In the potential range of 3.5–4.4V, it showed high discharge capacity and excellent cycling performance at 1/5, 1/2, 1C rate at 25°C and 55°C. The improvement in cycling performance might be contributed by the stabilization of spinel structure by smaller lattice constant when manganese ion was partially substituted by Co3+ ion. The spray-drying method is an effective method to prepare co-substituted lithium manganese oxide within very short production time, and thus is promising for commercial application.

Synthesizing Kinetics and Characteristics for Spinel Limn2o4 with the Precursor Using As Lithium-Ion Battery Cathode Material

Study on Kinetics of Synthesizing Spinel LiMn2O4 for Lithium-ion Battery Cathode

Synthesizing Kinetics and Characteristics of LiMnCoO4 Using As Lithium-Ion Battery Cathode Material

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Synthesis and Electrochemical Characteristics of Spinel Limn2o4 Via A Precipitation Spray-Drying Process

Optimum Synthesis of Spinel Phase LiMn_2O_4 by Rheological Phase Reaction Method

Electrochemical performance of LiMn2O4 synthesized from precursor Mn3O4

Synthesis and Electrochemical Properties of Nanostructured LiMn2O4 for Lithium-Ion Batteries

Preparation of Limn2o4 with an Enhanced Performance by Mixed Liquid and Mechanical Activations

Structural, Morphological and Electrochemical Characteristics of Spinel Limn2o4 Prepared by Spray-Drying Method

Preparation of Spinel LiMn2O4 from Manganese Oxide and Its Electrochemical Performance

Preparation and electrochemical properties of cathode materials Li1+xMn2O4 for lithium ion batteries

Spinel Li1 + Xmn2o4 Synthesized by Coprecipitation As Cathodes for Lithium-Ion Batteries

Studies on an LiMnO Spinel System (obtained by Melt-Impregnation) As a Cathode for 4 V Lithium Batteries Part 1. Synthesis and Electrochemical Behaviour of LixMn2O4

Lithium Ion Adsorption–desorption Properties on Spinel Li4Mn5O12 and Ph-Dependent Ion-Exchange Model

Characteristics and Active Energy for the Precursor of Lithium Manganese Oxides

Preparation Of Nanocompound Oxide Limn2o4 And Characterization Of Its Electrochemical Properties

Synthesis and Electrochemical Properties of Spinel Lico1/6mn11/6o4 Powders by A Spray-Drying Method

Preparation of Cathode Materials for Lithium Batteries by Melt Impregnation Method .1. Preparation of Spinel Limn2o(4)

Preparation of LiMn2O4 by two methods for lithium ion batteries

Synthesis of Highly Crystalline Spinel Limn2o4 by A Soft Chemical Route and Its Electrochemical Performance