Abstract:Co-substituted LiCo1/6Mn11/6O4 powders were prepared by a spray-drying method for positive electrodes of lithium ion batteries. The heat treating process, crystal structure and electrochemical properties of the synthesized materials were investigated by TG/DTG, DSC, XRD, SEM, slow rate cyclic voltammetry (CV) and galvanostatic charge/discharge cycling tests. The final powders were identified as single-phase spinel LiCo1/6Mn11/6O4 with high degree of crystallization and uniform particle size distribution. In the charge/discharge potential (versus Li/Li+) ranging from 2.0 to 4.4V, the LiCo1/6Mn11/6O4 electrode delivered high initial discharge capacity of 242mAhg−1 at 1/10C rate at 25°C. In the potential range of 3.5–4.4V, it showed high discharge capacity and excellent cycling performance at 1/5, 1/2, 1C rate at 25°C and 55°C. The improvement in cycling performance might be contributed by the stabilization of spinel structure by smaller lattice constant when manganese ion was partially substituted by Co3+ ion. The spray-drying method is an effective method to prepare co-substituted lithium manganese oxide within very short production time, and thus is promising for commercial application.

Structural, Morphological and Electrochemical Characteristics of Spinel Limn2o4 Prepared by Spray-Drying Method

Synthesis and Electrochemical Characteristics of Spinel Limn2o4 Via A Precipitation Spray-Drying Process

Spray-drying method to synthesis LiMn1.5Ni0.5O4 and its electrochemical characteristics as a cathode material

Synthesis and Electrochemical Properties of Spinel Lico1/6mn11/6o4 Powders by A Spray-Drying Method

Preparation of Submicrocrystal LiMn2O4 Used Mn3O4 As Precursor and Its Electrochemical Performance for Lithium Ion Battery

Preparation of LiMn2O4 by two methods for lithium ion batteries

Electrochemical Study on LiMn2O4 As Cathode Material for Lithium Ion Batteries

Synthesis of Highly Crystalline Spinel Limn2o4 by A Soft Chemical Route and Its Electrochemical Performance

Preparation of Limn2o4 with an Enhanced Performance by Mixed Liquid and Mechanical Activations

Effects of Ni-ion Doping on Electrochemical Characteristics of Spinel LiMn2O4 Powders Prepared by a Spray-Drying Method

One-Step Synthesis Limn2o4 Cathode by A Hydrothermal Method

Spray-drying Process for Synthesis of Nanosized LiMn 2 O 4 Cathode

Synthesis Spinel Limn2o4 With Manganese Carbonate Prepared By Microemulsion Method

Synthesis of Spinel Limn2o4 for Li-Ion Batteries Via Sol-Gel Process

LIMN2O4 SPINEL DIRECT SYNTHESIS AND LITHIUM ION SELECTIVE ADSORPTION

Preparation, Characteristics and Electrochemical Properties of Surface-Modified Limn2o4 by Doped Lini0.05mn1.95o4

Synthesis and Characterization of Sn-Doped Limn2o4 Cathode Materials for Rechargeable Li-Ion Batteries

Electrochemical Performance of Nanosized LiMn2O4 for Lithium-Ion Batteries

Synthesis Conditions Of Limn2o4 Prepared By Molten Salt Method

Electrochemical Performance of Li4Mn5O12 Nano-Crystallites Prepared by Spray-Drying-assisted Solid State Reactions

Preparation of Cathode Materials for Lithium Batteries by Melt Impregnation Method .1. Preparation of Spinel Limn2o(4)