Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Design and Simulation of a MEMS Fabry–Perot Accelerometer with Ultra-Low Cross-Axis Sensitivity

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

Monolithic Integrated Micro-Opto-Electromechanical Accelerometer Based on Michelson Interferometer Structure

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement

Design and Modification of a High-Resolution Optical Interferometer Accelerometer

A MEMS Based Fabry–Pérot Accelerometer with High Resolution

Resonant MEMS Accelerometer with Low Cross-Axis Sensitivity—Optimized Based on BP and NSGA-II Algorithms

A Low Cross-Axis Sensitivity Micro-Grating Accelerometer With Double-Layer Cantilever Beams

3-axis Capacitive Low-Gravity MEMS Accelerometer with Zero Cross-Axis Sensitivity in a Commercial Process

High Sensitivity Optical MEMS Accelerometer Based on a Metal Fabry–Pérot Microcavities Wavelength Modulation System

A Two-Axis MEMS Piezoresistive In-Plane Accelerometer with Pure Axially Deformed Microbeams

Design and Measurement of a Piezoresistive Triaxial Accelerometer Based on MEMS Technology

Design And Fabrication Of A Slanted-Beam Mems Accelerometer

A Monolithic Three-Axis Accelerometer With Low Cross-Axis Sensitivity

In-plane Dual-axis MEMS Resonant Accelerometer with A Uniform Sensitivity

Development of a MEMS Piezoresistive High-g Accelerometer with a Cross-Center Block Structure and Reliable Electrode

Modeling and Characterization of a Novel In-Plane Dual-Axis MEMS Accelerometer Based on Self-Support Piezoresistive Beam

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer