Abstract:Control of wrinkle for its utilization in tube hydroforming process is a challengeable subject up to now, because wrinkle was always considered as one of the tube's defects from the traditional view. In order to investigate the flattening behavior of wrinkles in the calibration stage, the wrinkled 5A02 aluminum alloy tubes, obtained under different internal pressures with same amount of axial feeding, were used as the preformed samples for the hydroforming under higher internal pressure of 15 p (s) (p (s) represents the initial yield pressure of tube). The effect of internal pressure during wrinkling process, as well as the axial feeding, on the flattening behavior of wrinkles was investigated and discussed. It has been found that the wrinkles can be flattened completely when the wrinkling internal pressure is 1.8 p (s) . Furthermore, when the axial feeding ratio is reduced from 80 to 75 %, the wrinkling internal pressure range for fractured wrinkles in calibration stage will be enlarged backward to 1.2 p (s) , but the pressure range for useful wrinkles can be improved forward to 1.6 p (s) . In addition, the fitted Gauss function for every wrinkle was integrated in order to compare its area with the corresponding area of die cavity, so as to reveal the flattening behavior of the wrinkles. It is shown that the wrinkles are easier to be flattened completely without any dead wrinkles when the surface areas of left and right wrinkles are smaller than their die cavity, and the surface area of middle wrinkle is bigger than its die cavity.

Research on wrinkling behavior in tube hydroforming

Control and use of wrinkles in tube hydroforming

Effect of Wrinkling Behavior on Formability and Thickness Distribution in Tube Hydroforming

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

WRINKLING BEHAVIOR IN HYDROFORMING OF UNSYMMETRICAL TUBULAR PART

Analysis of Plastic Wrinkling Behavior in Tube Hydroforming Process

Numerical simulation of wrinkling in hydroforming of aluminum alloy tubes

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Effect of Wrinkles on Formability in Hydroforming A Double-Diameter Aluminum Alloy Tubular Part

Analysis on wrinkling and cracking initiation in hydroforming thin?walled Y?shaped tubes

Wrinkling Behavior in Tube Hydroforming Coupled with Internal and External Pressure

Research on Bursting Behavior in Hydroforming of Double-Cone Tube

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

Wrinkling Behavior of Magnesium Alloy Tube in Warm Hydroforming

Thickness Improvement in Hydroforming of a Variable Diameter Tubular Component by Using Wrinkles and Preforms

Analysis on Corner Wrinkling for Axial Hydro-Forging of Variable-Diameter Tube

Deformation and defects in hydroforming of Y-shaped tubes

Analysis of Warping Failure in Tube Hydro-Forging

Research on Flattening Behavior of Wrinkled 5A02 Aluminum Alloy Tubes under Internal Pressure

Analysis on Critical Conditions of Sidewall Wrinkling for Hydroforming of Thin-Walled Tee-Joint

Investigation into the Pre-Forming'S Effect During Multi-Stages of Tube Hydroforming of Aluminum Alloy Tube by Using Useful Wrinkles