Abstract:Large diameter thin-walled tubes are prone to wrinkle due to a low stability of anti-wrinkles, non-uniform material flow, and contact sequence to the die cavity during hydroforming process. Although wrinkling defects can be controlled by reducing the diameter of the initial tube to some extent, the severe thinning will occur. A method of using local constraints was proposed to eliminate wrinkling defects that occurred on thin-walled hydroformed tubes. The effect of axial constraint, hoop constraint, and axial-and-hoop constraint on wrinkling behavior of large diameter thin-walled tubes has been investigated by using numerical simulation and experiment methods. In addition, the trajectory of principal stress of the wrinkling zones with different local constraints has been discussed. The results show that axial compressive stress of the two wrinkling zones can be reduced by 6.8 and 23.0% by using axial constraint, respectively. Hoop constraint reduces axial compressive stress by 11.7% at the two wrinkling zones. And the axial compressive stress remarkably decreased by 22.3 and 31.8% using axial-and-hoop constraint. The results reveal that the application of local constraints can effectively restrict the occurrence of wrinkle by decreasing axial compressive stress during hydroforming of large diameter thin-walled tubes. Finally, a desired part without defects has been manufactured successfully by axial-and-hoop constraint.

Effect of Wrinkling Behavior on Formability and Thickness Distribution in Tube Hydroforming

Research on wrinkling behavior in tube hydroforming

Control and use of wrinkles in tube hydroforming

WRINKLING BEHAVIOR IN HYDROFORMING OF UNSYMMETRICAL TUBULAR PART

Effect of Wrinkles on Formability in Hydroforming A Double-Diameter Aluminum Alloy Tubular Part

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Thickness Improvement in Hydroforming of a Variable Diameter Tubular Component by Using Wrinkles and Preforms

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Numerical simulation of wrinkling in hydroforming of aluminum alloy tubes

Analysis of Plastic Wrinkling Behavior in Tube Hydroforming Process

Wrinkling Behavior in Tube Hydroforming Coupled with Internal and External Pressure

Research on Bursting Behavior in Hydroforming of Double-Cone Tube

Wrinkling Behavior of Magnesium Alloy Tube in Warm Hydroforming

Investigation into the Pre-Forming'S Effect During Multi-Stages of Tube Hydroforming of Aluminum Alloy Tube by Using Useful Wrinkles

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Analysis on wrinkling and cracking initiation in hydroforming thin?walled Y?shaped tubes

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

Simulation and Experiment on Warm Hydroforming of Az31 Magnesium Alloy Tube

Experimental and Numerical Investigation into Useful Wrinkling During Aluminium Alloy Internal High-Pressure Forming

Deformation and defects in hydroforming of Y-shaped tubes

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube