Abstract:Control of wrinkle for its utilization in tube hydroforming process is a challengeable subject up to now, because wrinkle was always considered as one of the tube's defects from the traditional view. In order to investigate the flattening behavior of wrinkles in the calibration stage, the wrinkled 5A02 aluminum alloy tubes, obtained under different internal pressures with same amount of axial feeding, were used as the preformed samples for the hydroforming under higher internal pressure of 15 p (s) (p (s) represents the initial yield pressure of tube). The effect of internal pressure during wrinkling process, as well as the axial feeding, on the flattening behavior of wrinkles was investigated and discussed. It has been found that the wrinkles can be flattened completely when the wrinkling internal pressure is 1.8 p (s) . Furthermore, when the axial feeding ratio is reduced from 80 to 75 %, the wrinkling internal pressure range for fractured wrinkles in calibration stage will be enlarged backward to 1.2 p (s) , but the pressure range for useful wrinkles can be improved forward to 1.6 p (s) . In addition, the fitted Gauss function for every wrinkle was integrated in order to compare its area with the corresponding area of die cavity, so as to reveal the flattening behavior of the wrinkles. It is shown that the wrinkles are easier to be flattened completely without any dead wrinkles when the surface areas of left and right wrinkles are smaller than their die cavity, and the surface area of middle wrinkle is bigger than its die cavity.

Effect of Wrinkles on Formability in Hydroforming A Double-Diameter Aluminum Alloy Tubular Part

Effect of Wrinkling Behavior on Formability and Thickness Distribution in Tube Hydroforming

WRINKLING BEHAVIOR IN HYDROFORMING OF UNSYMMETRICAL TUBULAR PART

Research on wrinkling behavior in tube hydroforming

Wrinkling Behavior of Magnesium Alloy Tube in Warm Hydroforming

Wrinkle Behavior of Hydroforming of Aluminum Alloy Double-Layer Sheets

Control and use of wrinkles in tube hydroforming

Numerical simulation of wrinkling in hydroforming of aluminum alloy tubes

Wrinkling Behavior in Tube Hydroforming Coupled with Internal and External Pressure

Investigation into the Pre-Forming'S Effect During Multi-Stages of Tube Hydroforming of Aluminum Alloy Tube by Using Useful Wrinkles

Experimental and Numerical Investigation into Useful Wrinkling During Aluminium Alloy Internal High-Pressure Forming

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Thickness Improvement in Hydroforming of a Variable Diameter Tubular Component by Using Wrinkles and Preforms

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Research on Flattening Behavior of Wrinkled 5A02 Aluminum Alloy Tubes under Internal Pressure

Effect of Strain State on the Surface Roughening for Hydroforming of Aluminum Alloy Tube Based on Cross-Scale Numerical Modeling

Analysis of Wrinkling Behavior of Hydroformed Torsion Beam

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

The Effect of Upper Sheet on Wrinkling and Thickness Distribution of Formed Sheet Part Using Double-Layer Sheet Hydroforming

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube