Abstract:To overcome the problems in forming the variable-diameter tubes by tube hydroforming, such as excessive thinning and high internal pressure, a new approach named axial hydro-forging sequence was proposed. In this approach, the tube was expanded to fill the die cavity firstly and then the thinning ratio was reduced by axial compression deformation produced in axial hydro-forging sequence. To demonstrate the feasibility of this approach, two mechanical conditions were theoretically analyzed in this study include axial hydro-forging condition and deformation sequence. Based on the plastic energy method, a critical wrinkling model for axial hydro forging sequence was established to calculate the critical wrinkling internal pressure. It was observed that there was a critical wrinkling internal pressure in the axial hydro-forging sequence, and the critical wrinkling internal pressure increased with increasing the tube axial shortening and material strength coefficient, but decreased with the increase of strain hardening coefficient. At the same time, an analytical model based on mechanical analysis was developed to discuss the deformation sequence for different deformation zones. The results showed that the deformation sequence of the three characteristic zones in the process was as follow: maximum diameter zone > transition zone > guide zone, which satisfied the requirement of reducing the thinning ratio. Finally, experiments along with the finite element simulation were performed to validate the analytical model, and effects of key process parameters on tube forming were revealed. As a result, variable-diameter tubes were successfully produced by this approach, which indicated that the axial hydro-forging sequence is a feasible forming approach for the fabrication of tubes with variable diameters.

Analysis on Corner Wrinkling for Axial Hydro-Forging of Variable-Diameter Tube

Analysis of Transition Corner Formation in Hydroforming of Rectangular-Section Tube

Research on wrinkling behavior in tube hydroforming

Analysis of Corner Filling Behavior During Tube Hydro-Forming of Rectangular Section Based on Gurson–Tvergaard–Needleman Ductile Damage Model

Analysis of Plastic Wrinkling Behavior in Tube Hydroforming Process

Analysis of Warping Failure in Tube Hydro-Forging

Analysis of Thinning at the Transition Corner in Tube Hydroforming

Control and use of wrinkles in tube hydroforming

Analysis on Critical Conditions of Sidewall Wrinkling for Hydroforming of Thin-Walled Tee-Joint

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Study on Wrinkling Behavior in Hydroforming of Large Diameter Thin-Walled Tube Through Local Constraints

Axial Hydro-Forging Sequence for Variable-Diameter Tube of 6063 Aluminum Alloy

WRINKLING BEHAVIOR IN HYDROFORMING OF UNSYMMETRICAL TUBULAR PART

Study on the Factors Affecting the Corner Filling Process in Hydroforming

Investigation of Thickness Variation in Axial Hydro-Forging Sequence for Variable-Diameter Tubes

Analysis of Wrinkling Behavior of Hydroformed Torsion Beam

Analysis on wrinkling and cracking initiation in hydroforming thin?walled Y?shaped tubes

Filling Behavior of Transition Corner in Hydroforming of Aluminum Alloy Rectangular Section Tube

Wrinkling Behavior in Tube Hydroforming Coupled with Internal and External Pressure

Effect of Strain State on the Surface Roughening for Hydroforming of Aluminum Alloy Tube Based on Cross-Scale Numerical Modeling

Analysis of wrinkling during sheet hydroforming of curved surface shell considering reverse bulging effect