Abstract:The Journal of Strain Analysis for Engineering Design, Ahead of Print. In the present work, the process chain in tube production by roll forming of the steel 34MnB5 was examined in more detail. The process chain consisting of the steps (i) roll forming, (ii) HFI welding, and then (iii) straightening and final calibration was mapped using the finite element method. In addition to the pipe geometry, the residual stress distribution was considered as an essential target value for the assessment of the performance of the tubes under service conditions. The objective of the project is to describe the manufacturing process and thus the processing induced residual stress distributions as realistically as possible. For a more detailed characterization of the process and above all for the validation of the numerical simulations, experimental residual stress analyses were carried out for the final state of the tubes using complementary analysis methods. The contour method was used to determine the 2D-distribution of residual stresses across the transverse and longitudinal sections of the manufactured pipes. These measurements were supplemented by local residual stress analyses using the incremental hole drilling method and X-ray residual stress analyses. The work thus pursues both a methodical approach to the analysis of the internal stresses induced by the process using complementary methods and also a manufacturing approach to the analysis and evaluation of the production chain. In particular for the axial components of the residual stresses, it can be shown that experimentally determined residual stresses correlate well with the numerically calculated values. The contour method is excellently suited to monitor the uneven distribution of the internal stresses over the pipe cross-section. The results of the simulation show that the overall residual stress distribution that is determined using the contour method mainly results from the plastic strains introduced by the roll forming process. X-ray and hole drilling analyses are shown to be more suitable for measuring locally present residual stresses at defined positions on the outer tube surface. In this way it can be shown that the simulation approach described provides an accurate model of the process.

Evolution of inner wall wrinkle defects in the sinking zone of a thick-walled steel tube during radial forging

Formation criterion of fissure defects in the inner wall of the radial forged steel tube

Inner Surface Morphology and Roughness Evolution of Pilgering Thick-Walled Tubes

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Analysis of the wall thickness distortion in tube hydro-forging

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Plastic wrinkling of thin-walled tubes under axial compression in non-uniform temperature field

Predicting the wrinkling in AA5052 seamless tubes manufactured by free bending forming technology

Analysis and Control of Cracking and Wrinkling at the End of Seamless Steel Tube with Multi-Pass Large Deformation Diameter-Reducing

Influence of Cold-Rolling Processes on the Dimensional Accuracy and Roughness of Small-Diameter Thick-Walled Seamless Tubes

A new tube forging process for manufacturing hollow parts with inner flange at an arbitrary location

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Investigation on the inner hole spiral-groove of cross wedge rolling of hollow shafts with mandrel

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Material Flow in Infeed Rotary Swaging of Tubes

Evolution behaviors of inclusions in warm‐rolled L605 thin‐walled tubes and their effects on machinability

Investigation of the Bright and Dark Line on the Inner Wall of a Thin-Walled Copper Tube by Drawing with a Floating Plug

The microstructure, texture evolution and plasticity anisotropy of 30SiMn2MoVA high strength alloy steel tube processed by cold radial forging

Influence of Process Fluctuations on Residual Stress Evolution in Rotary Swaging of Steel Tubes

Microstructural and Textural Evolution of a Zr-Sn-Nb-Fe Alloy Tube During Cold Pilger Rolling

Experimental and numerical analysis of residual stresses induced by the manufacturing process of longitudinal welded tubes