Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Understanding the Impact of Fibre Wrinkle Architectures on Composite Laminates Through Tailored Gaps and Overlaps

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Damage and Failure Mechanisms of CFRP Due to Manufacturing Induced Wrinkling Defects

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Plastic wrinkling prediction in thin-walled part forming process: A review

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Formability limits by wrinkling in sheet metal forming

An analytical model for designing defect-free sheet metal profiles with height-variable cross sections manufactured by Flexible Roller Beading

Characterization of wrinkle morphologies by surface waviness evaluation method during deep forming of multilayer composite preforms

Surface Wrinkling of an Elastic Graded Layer.

Sidewall wrinkling suppression in the hydro-mechanical deep drawing for the curved surface shell of titanium/iron composite sheets

Plastic wrinkling of thin-walled tubes under axial compression in non-uniform temperature field

Efficient approach to plastic wrinkling prediction for multi-intersecting stiffened panels in spherical die forming

Surface effects on the wrinkles in a stiff thin film bonded to a compliant substrate

Predicting the wrinkling in AA5052 seamless tubes manufactured by free bending forming technology

A novel assessment method for wrinkle defects in composites

Suppressing Wrinkles in Thin-Walled Dome Parts: A Novel Deep Drawing Method with Active Stress Control

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Theoretical Prediction of Flange Wrinkling in the First-Pass Conventional Spinning of Dual-Metal Sheets