Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Sidewall wrinkling suppression in the hydro-mechanical deep drawing for the curved surface shell of titanium/iron composite sheets

Experimental and Numerical Studies on the Formability of TB5 Titanium Sheet in Rubber Cold Forming

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Wrinkling and Strengthening Behaviors in the Two-Layer-Sheet Hot-Forming–Quenching Integrated Process for an Al–Cu–Mg-Alloy Thin-Walled Curved-Surface Shell

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Suppressing Wrinkles in Thin-Walled Dome Parts: A Novel Deep Drawing Method with Active Stress Control

Enhancing formability in deep drawing: A 3D finite element analysis of plastic wrinkling in AA2090 Al–Li alloy

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Inhibiting plastic tensile instability of non-symmetric thin-walled shell component via increasing regional metal inflow based on heterogeneous pressure-carrying medium

Study on the mechanism of wrinkle flattening under internal pressure and the critical condition of dead wrinkle

Numerical investigation of controllable non-uniform deformation of tailor-welded blanks using heterogeneous pressure-carrying medium

Mechanism of pre-deformation effect on sheet deep-drawing forming under magnetic field condition using a magnetorheological fluid (MRF) medium

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Development of Experimental Method to Improve Sheet Metal Formability by Transverse Normal Stress

Hybrid forming process combining electromagnetic and quasi-static forming of ultra-thin titanium sheets: Formability and mechanism

Loading conditions constrained wrinkling behaviors of thin-walled sheet/tube parts during metal forming

Investigation of forming defects in 5A06 aluminum alloy cold stamping of thin-walled shell with corner

Regional control of sheet metal formability via establishing differentiated pressure field using heterogeneous elastomers in flexible die forming process

Study on warm forming process of rigid-flexible composite drawing based on numerical simulation

Numerical and experimental analysis of defects control in cross wedge rolling for titanium alloy workpieces

Deformation behavior and interface microstructure evolution of Al/Mg/Al multilayer composite sheets during deep drawing