Process parameters optimization of differential heating push-bending for small bending radius tube based on orthogonal experiments
Mingliang Peng,Xuefeng Xu,Yubin Fan,Jie Xiao,Liming Wei,Jun Xie,Dong Yang
DOI: https://doi.org/10.1007/s00170-024-13916-x
IF: 3.563
2024-06-14
The International Journal of Advanced Manufacturing Technology
Abstract:A process of differential heating push-bending (DHP-B) was proposed to enhance the forming quality of thin-walled tubes with small bending radius. Finite element numerical simulation and the orthogonal test method were employed to optimize the process parameters, including temperature, friction coefficients of the inner and outer deformation zones ( Z 1 and Z 2 ) as well as the guide zone ( Z 3 ), and the reverse thrust, for bending 5A02 aluminum alloy tubes with a diameter of 32 mm, a wall thickness of 1 mm, and a relative bending radius of 0.9. The thinning rate, ovality, and push-out amount were taken as the evaluation indexes to determine the primary and secondary relationships between the factors by the comprehensive balance method. Temperature, among these factors, had the most significant impact on these evaluation indexes. The variation of friction coefficient mainly affected thinning rate and ovality, whereas the reverse thrust primarily affected the push-out amount. The optimal parameter combinations were identified as a temperature of 300 °C, friction coefficient Z 1 of 0.1, Z 2 of 0.1, Z 3 of 0.03, and reverse thrust of 27 MPa, as revealed by the results. Finally, the simulation results were validated by experiments.
engineering, manufacturing,automation & control systems