Abstract:A Monte Carlo Potts model, including anisotropic boundary energies and mobilities, has been used to investigate cube texture evolution. The work is motivated by the post-recrystallization grain growth seen during annealing of highly cold-rolled nickel sheets, It is observed that during such grain growth the cube texture fraction increases from approx. 50% to more than 95%. Electron back-scatter diffraction orientation measurements of fully recrystallized samples have been used to provide starting microstructures for simulations examining the effect of the texture tightness on the development of the cube texture during grain growth. The texture evolution of a single texture component with an initial average size advantage is controlled predominantly by this size advantage once the initial texture spread of this component falls below some value. An additional set of simulations was also carried out to examine grain growth in systems with a quasi-binary texture. The simulations were used to examine cases of grain growth in where one component has a larger average grain size, but where there is still a significant overlap in the grain-size distribution of each component. The initial microstructures were constructed to give different fractions of each texture component, with a given value of both the mean size and the texture spread of each component. The simulations suggest that for such systems there is a well defined range of conditions for which a single texture component can grow to dominate the final texture.

Cube texture in heavily cold rolled pure nickel

Development of the Cube Texture at Low Annealing Temperatures in Highly Rolled Pure Nickel

Preparation of cube texturing Ni plate by rolling and recrystallization

Development and Stability During High Temperature Annealing of the Cube Texture in Rolled Ni Substrate Materials

Effects of an external electric field on cube texture development of rolled pure nickel during recrystallization

Deformation And Annealing Textures Of Extruded And Cold Rolled Pure Ni Single Crystals Of Cube Orientation

Microstructure Evolution and Texture Characteristics of Pure Nickel N6 During Cold Rolling Process

Recrystallization Texture in Nickel Heavily Deformed by Accumulative Roll Bonding

Effect of cross cold rolling and annealing on microstructure and texture in pure nickel

Strong Cube Texture Formation in Heavily Cold-Rolled Ni8W/Ni12W/Ni8W Composite Alloy Substrates Used in YBCO Coated Conductors

Monte Carlo Simulation of Cube-Texture Evolution During Grain Growth of High-Purity Nickel

Modeling of Cube-Texture Evolution During Grain Growth in Ni Thick-Films Based on Experimental Observations

Cube Texture Development in Pure Ni during Annealing in a High Strength Magnetic Field

Systematical Analysis on the Grain Orientation Evolution of Pure Nickel under Plastic Deformation by Using In-Situ EBSD

Effect of Reduction on High Temperature Annealing of Cold-Rolled Ni

Microstructure and Texture Evolution of Cu-Ni-P Alloy after Cold Rolling and Annealing

Texture and Deformation Structure Evolution During Rolling of Individual Grains of Columnar Grain Nickel

Systematic investigation of the texture evolution of Cu-Ni alloys with different strains

Evolution of Microstructure, Texture and Topography During Cold Rolling and Recrystallization of Ni–5at.%W Alloy Substrate for Coated Conductors

Effect of Annealing Temperature on Cube Texture Formation in Ni7W/Ni12W/Ni7W Compound Substrate

Preparation and Evaluation of Cube Texture Ni Substrate for Ybco-Coated Superconductor