Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Research on New Displacement Sensor Used in Active Magnetic Bearing Systems

Circularity Error Analysis of Axial Displacement Sensor Detecting Surface for Active Magnetic Bearings of 10MW High Temperature Gas-Cooled Reactor (HTR-10GT)

Analysis and Experimental Study on Uncertain Fault of Active Magnetic Bearing Displacement Sensor

Research on transverse flux radial displacement sensor

DESIGN AND IMPLEMENTATION OF REDUNDANT SENSORS IN ACTIVE MAGNETIC BEARING

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

A novel approach for sensitivity improvement of axial inductive displacement sensor

High-precision micro-displacement sensor based on tunnel magneto-resistance effect

Study on Inverter-fed Three-pole Active Magnetic Bearing

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Research on Sensitivity of Axial Inductive Displacement Sensors with Constant Flux for Magnetic Bearings

Research on Flux Observers in Active Magnetic Bearings

Axial Active-Passive Suspension Electromagnetic System in Radial Air Gap for the Maglev Pump.

Radial Displacement Measurement Method in Bearingless Slice Motor Through Eddy Current Displacement Sensors Positioned on the Underside of the Rotor

Analysis and design of axial inductive displacement sensor

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias

The Precise Modeling and Analysis of Demodulation Approach in Self-sensing Active Magnetic Bearings

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

An Absolute Linear Displacement Sensor Based on Orthogonal Dual Traveling Wave Magnetic Field

Electromagnetic field analysis and modeling of a relative position detection sensor for high speed maglev trains