Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Research on Flux Observers in Active Magnetic Bearings

Power Amplifier for Active Magnetic Bearings Based on Flux Observer

Force Gain of a Flux Control Power Amplifier for Active Magnetic Bearings

Study on Inverter-fed Three-pole Active Magnetic Bearing

Switch point self-tuning method of combined flux observers in active magnetic bearings

Self-sensing Active Magnetic Bearing Using Real-Time Duty Cycle

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

The Precise Modeling and Analysis of Demodulation Approach in Self-sensing Active Magnetic Bearings

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

A measurement method for support characteristics of active magnetic bearings based on multi-DOF rotor system model

Research on Sensorless Control Method of PMSM Based on an Adaptive Sliding Mode Observer

Experimental Investigation on Dynamic Behaviour of Active Magnetic Bearing-Rotor System Subject to Base Vibration

Flux Linkage Observation Using an Improved MRAS Observer in Case of Uniform Demagnetization of IPMSM

Automatic Measurement of Stiffness and Damping of Active Magnetic Bearings

Nonlinear Flux Observer for Sensorless Control of IPMSM Based on a Novel Regression Model

Vibration Control of an Active Magnetic Bearings Flexible Rotor System Based on Adaptive Recursive Least Square Algorithm

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Sliding Mode Control Based on Linear Quadratic Regulator for an Active Magnetic Bearing Flexible Rotor Virtual Collocated System