Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Power Amplifier for Active Magnetic Bearings Based on Flux Observer

Force Gain of a Flux Control Power Amplifier for Active Magnetic Bearings

Research on Flux Observers in Active Magnetic Bearings

A Pwm Based Switching Power Amplifier for Active Magnetic Bearings

Study on Inverter-fed Three-pole Active Magnetic Bearing

A Current-Control Mode Three-Level Pwm Switching Power Amplifier for Active Magnetic Bearings

Design of the Switching Power Amplifier for Active Magnetic Bearing

Optimization Research on a Switching Power Amplifier and a Current Control Strategy of Active Magnetic Bearing

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Self-sensing Active Magnetic Bearing Using Real-Time Duty Cycle

The Precise Modeling and Analysis of Demodulation Approach in Self-sensing Active Magnetic Bearings

Output Feedback Dynamical Compensation Via EigenStructure Assignment for Active Magnetic Bearings-Rigid Rotor Systems.

Active Magnetic Bearing Amplifier Design based on SiC Devices

Vibration Control of Base-Excited Rotors Supported by Active Magnetic Bearing Using a Model-Based Compensation Method

Failure Mechanism of One Kind of Three-level PWM Switching Power Amplifier for Active Magnetic Bearings

Failure mechanism of three-level power amplifier for active magnetic bearings

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Research on the Performance of 3-State Power Amplifiers for Magnetic Bearings

A measurement method for support characteristics of active magnetic bearings based on multi-DOF rotor system model

Vibration Suppression of Base-Excited Rotors Supported by Active Magnetic Bearings Based on an Augmented Kalman Compensator

Study of switching power amplifier for active magnetic bearing