Failure Mechanism of One Kind of Three-level PWM Switching Power Amplifier for Active Magnetic Bearings

ZHOU Dan,ZHU Changsheng
2010-01-01
Abstract:In power amplifiers for active magnetic bearings, three-level modulation technique is commonly used to reduce the current ripple of the switching mode power amplifiers, so as to improve the performance of active magnetic bearing system. In our research, it is found that when a modified three-level pulse width modulation (PWM) modulation technique is used in power amplifiers for active magnetic bearings, the output current waveform of the power amplifier is inconsistent with the theoretical three-level waveform sometimes, and at the same switching frequency, the current ripple of the modified three-level PWM power amplifier is much bigger than the theoretical value. The failure phenomenon was introduced and the failure mechanism of the modified three-level PWM power amplifier was theoretically analyzed for different carrier waves based on the analysis of the modified three-level PWM modulation technology in this paper. It is found that the deviation of bias voltage setting in the modified three-level PWM generation circuit results in its failure, and the failure mechanism is different for different carrier waves. Simulation and experimental results are in agreement with the theoretical analyses. Finally, some suggestions about avoiding the failure of the modified three-level PWM power amplifier are presented. © 2010 Chinese Society for Electrical Engineering.
What problem does this paper attempt to address?