Abstract:With more and more widely used in the industrial field, Active Magnetic Bearings (AMB) have bigger challenge, such as the size and the load capacity are larger than before. In order to increase the reliability of the whole system, a lot of aspects have to be improved to adapt some special industrial requirements. Just like the 10MW high temperature gas-cooled test module reactor (HTR-10GT) with the core made of spherical fuel elements, which was designed and constructed by the Institute of Nuclear and New Energy Technology of Tsinghua University in China, take the AMB as the support bearings. HTR-10GT is the reactor with 3.5 meter long rotor, 230mm diameter, and 15000rpm Rated speed. Since there are some difficulties in HTR-10GT including the blade stages, small gap and so on, the high precision control on magnetic bearing is required very much. Once any part in the system is out of work, the rotor would happen to vibrate, which will lead to turbine blades scraping. The consequences could be disastrous especially when the system is in full power at the rated speed [1]. As you know, the electronic control system is the weakest point in AMB, both in operating site and the control room. Therefore, before engineering applications, the electronic control system must be tested for Electromagnetic Compatibility (EMC). Based on the experimental results, some design would be optimized, to improve anti-interference capability to meet the requirements of HTR-10GT. This paper describes the testing process and gives some solutions for EMC problems during the Electro Magnetic Susceptibility (EMS) test, such as the grounding, cable, wiring, filtering etc. These methods are the fundamental basis for reducing interference and improving the reliability of AMB in the HTR-10GT.

Circularity Error Analysis of Axial Displacement Sensor Detecting Surface for Active Magnetic Bearings of 10MW High Temperature Gas-Cooled Reactor (HTR-10GT)

Research on New Displacement Sensor Used in Active Magnetic Bearing Systems

DESIGN AND EXPERIMENTS OF THE ACTIVE MAGNETIC BEARING SYSTEM FOR THE HTR-10

Characteristic analysis of rotor dynamics and experiments of active magnetic bearing for HTR-10GT

Research on Dynamics and Experiments about Auxiliary Bearings for the Helium Circulator of the 10MW High Temperature Gas-Cooled Reactor

Technical Design and Principle Test of Active Magnetic Bearings for the Turbine Compressor of Htr-10gt

DESIGN AND IMPLEMENTATION OF REDUNDANT SENSORS IN ACTIVE MAGNETIC BEARING

Numerical Analysis of Magnetically Suspended Rotor in HTR-10 Helium Circulator Being Dropped into Auxiliary Bearings

THE ELECTRO MAGNETIC COMPATIBILITY TESTS FOR THE AMB SYSTEM ON HTR-10GT

Adaptive Unbalance Vibration Control Of Active Magnetic Bearing Systems For The Htr-10gt

ICONE11-36524 PRELIMINARY MODAL ANALYSIS AND STRUCTURE DESIGN OF AN HTR-10 PCU ROTOR WITH AN ACTIVE MAGNETIC BEARING

Thermal Analysis and Simulation of Auxiliary Bearings and Its Application in the High Temperature Reactor-10

Dynamic Analysis for the Rotor Drop Process and Its Application to a Horizontal Rotor-Active Magnetic Bearing System in Helium Gas

The Study And Development Of Excitation Source For Sensors Of The Amb System In Htgr

Rejection of Synchronous Vibration Based on Generalized Adaptive Period Iteration Algorithm for Active Magnetic Bearing

NONSYNCHRONOUS VIBRATION OF THE ACTIVE MAGNETIC BEARINGS-ROTOR SYSTEM IN THE HIGH TEMPERATURE GAS-COOLED REACTOR

Magnetic Field Analysis of Active Magnetic Bearings for Helium Blower of Htr-Pm

Dynamic Behavior Of The Amb'S Vertical Arranged Rotor During Its Drop Process

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

Preliminary Research of Auxiliary Bearing in HTR-10GT Project

Measurement of Unbalance Vibration Phase for Active Magnetic Bearing in High Temperature Gas-Cooled Reactor