Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Analysis and Experimental Study on Uncertain Fault of Active Magnetic Bearing Displacement Sensor

Detection of Inter-Turn Short Circuit Fault of Active Magnetic Bearing Based on Least Mean Square Algorithm

Position Estimation Accuracy Improvement Based on Accurate Modeling of Self-Sensing Active Magnetic Bearings

Research on New Displacement Sensor Used in Active Magnetic Bearing Systems

Research on Flux Observers in Active Magnetic Bearings

Bearing Fault Diagnosis under Time-Varying Speed and Load Conditions Via Speed Sensorless Algorithm and Angular Resample

A Multifrequency Disturbances Identification and Suppression Method for the Self-Sensing AMB Rotor System

Study on Inverter-fed Three-pole Active Magnetic Bearing

A Sensor-Fault Tolerant Control Method of Active Magnetic Bearing in Flywheel Energy Storage System

DESIGN AND IMPLEMENTATION OF REDUNDANT SENSORS IN ACTIVE MAGNETIC BEARING

The Precise Modeling and Analysis of Demodulation Approach in Self-sensing Active Magnetic Bearings

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Cooperative Rotor Position Estimation of Active Magnetic Bearings with Unsaturated Magnetic Bias

Theoretical And Experimental Analysis On The Influence Of Rotor Non-Mechanical Errors Of The Inductive Transducer In Active Magnetic Bearings

Unbalance Compensation for Active Magnetic Bearing Rotor System Using a Variable Step Size Real-Time Iterative Seeking Algorithm.

Rotor Position Estimation Strategy for Self-Sensing Active Magnetic Bearing Considering Eddy Currents

Dynamic Stiffness Analysis and Experimental Verification of Axial Magnetic Bearing Based on Air Gap Flux Variation in Magnetically Suspended Molecular Pump

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Identification of Active Magnetic Bearing System with A Flexible Rotor

A Novel Three-Module Real-Time Adjustable Accuracy Speed Estimator for Active Magnetic Bearing System

Automatic Measurement of Stiffness and Damping of Active Magnetic Bearings