Abstract:As a surface-strengthening technology, electro-spark deposition (ESD) is widely used in the strengthening and repair of key components of high-end equipment. In this paper, a fusion and solidification model of ESD coating is established. The method of heat–fluid–solid interaction is adopted to simulate the material’s flow and fusion process in the droplet dropping into the molten pool. The distribution law of the coating-matrix material inside the coating was studied. Through the heat transfer between the molten material and the matrix material, the condensation and solidification process of the coating-matrix material is simulated, the temperature change in the coating area during the solidification process is analyzed, and the solidification law of the molten material is studied. The results show that the deposition time reaches 80 μs, and the content of electrode material at the bottom of the molten pool reaches 4.5%. The content of electrode material in the upper region of the material gushing out of the molten pool is higher than that in the bottom region. The material outside the molten pool solidifies first, and the molten material in the molten pool gradually solidifies from the bottom up; the shape of the solidification interface is similar to the boundary of the molten pool. Through the single-point deposition experiment of electro-spark deposition, the surface morphology of the deposition point was observed. The depth of the concave part of the contour can reach 16 μm. The difference between the two contour curves in the horizontal direction is not much; the error of the diameter is about 4%. The element distribution of the surface and the section of the deposition point are analyzed. The diffusion distance in the depth direction of the coating is about 4μm, and the transverse diffusion distance inside the coating is 364 μm. The error is 7.6% compared with the experimental results. The cross-section structure of the deposition point was observed, and the error between the experimental results and the simulation results in diameter is about 11%. It was found that the material distribution in the sedimentary area is basically consistent with the simulation results, and the simulation results are verified from the side.

Electrophoretic deposition and its application in ceramics processing

An Outline of the Fabrication of Ceramic Film by Low Temperature Deposition from Aqueous Solution

Preparation of Nano-Laminated Composite by Electrophoretic Deposition

Development of Uniform and Porous Al Coatings on FeCrAl Substrate by Electrophoretic Deposition

Combinatory electric-field-guided deposition for spatial microparticles patterning

Colloidal Forming Process of Ceramic Composites

New Colloidal Processing Techniques of Ceramic Powders

Fabrication of In-Ceram Dental Restoration by Aqueous Electrophoretic Deposition

RESEARCH PROGRESS OF NEW COLLOIDAL FORMING PROCESSES FOR ADVANCED CERAMICS

Electrophoretic deposition of hydroxyapatite/chitosan nanocomposites: the effect of dispersing agents on the coating properties

The newly deposited a Cu electrode on ferrite ceramics by added arc glow discharge method

Characterization and Application of Materials Grown by Electron-Beam-Induced Deposition

Interactions between lead-zirconate titanate, polyacrylic acid, and polyvinyl butyral in ethanol and their influence on electrophoretic deposition behavior

Surface Metallization and Ceramic Deposition on Thermoplastic-Polymer and Thermosetting-Polymer Composite Via Atmospheric Plasma Spraying

Fabrication Of A New Ceramic Coating By Electrophoretic Method For Graphite Electrodes At High Temperature

Research on Simulation of Coating Fusion and Solidification Process in Electro-Spark Deposition

Electrophoretic Deposition of Pb(Zr,Ti)O3 Powders on Silicon Wafer and Sintering Densification Approach

Chemical vapor processing and applications for nanostructured ceramic powders and whiskers

Application of Plasma Technique in the Development of Ceramic Material

Recent advances in multifunctional hydroxyapatite coating by electrochemical deposition

Experimental and numerical investigation of laser-assisted electrodeposition based on amorphous forming: Laser-electrodeposition correlation and explanation of enhancing mechanism