EDC of graphite using powder metallurgical green compact W-Cu tools
Rashed Mustafa Mazarbhuiya Maneswar Rahang Subhankar Saha Dhinakaran Veeman a Centre for Additive Manufacturing,Chennai Institute of Technology,Chennai,Tamil Nadu,Indiab Department of Mechanical Engineering National Institute of Technology Meghalaya,Shillong,Indiac Department of Mechanical Engineering,Brainware University,Kolkata,Indiad Center for Multidisciplinary Research & Innovations (CMRI),Brainware University,Kolkata,India
DOI: https://doi.org/10.1080/10426914.2024.2437754
IF: 4.7832
2024-12-05
Materials and Manufacturing Processes
Abstract:This paper investigates the Electro Discharge Coating method for modifying graphite surfaces by powder metallurgical green compact tool composed of 75% Tungsten+ 25% Copper by weight. Key input parameters include compact load (CL), peak current (I p ) and pulse on-time (T on ), while the output responses are tool wear rate (TWR), material transfer rate (MTR) and surface roughness (Ra). The coated surfaces undergo detailed characterization and analysis to assess their properties. A higher MTR of 52.25 mg/min, a TWR of 285.10 mg/min, a Ra of 6.10 μm and a layer thickness of 173.90 μm are measured at a CL of 10 ton, a I p of 4 A and a T on of 400 μs, whereas a lower MTR of 6.02 mg/min, a TWR of 48.02 mg/min, a Ra of 3.40 μm and a layer thickness of 35.72 μm are measured at CL of 20 ton, I p of 2A and T on of 100 μs.
materials science, multidisciplinary,engineering, manufacturing