Abstract:This work presents the adsorption behavior and appearance characteristics of CH4 and CO2 on the Longmaxi shale at high pressure and temperature. To investigate the variation of gas adsorption patterns under the constraint of pressure and temperature, the applicability of the theories of monolayer adsorption, multilayer adsorption, and micropore filling was discussed. The preferential selection coefficient of CO2 for CH4 under different conditions was characterized by the absolute adsorption capacity (Vabs) ratio of CO2 to CH4 (αCO2/CH4). Moreover, the implication of the CO2 injection to enhance gas recovery and the CO2 capture and storage (EGR–CCS) process was analyzed. The results exhibit that the excess adsorption curves of CH4 are smooth, and the experimental temperature has no noticeable effect on the shape of curves. At the same time, a "sharp peak" is recorded in the excess adsorption curves of CO2 at low temperatures (30 and 55 °C) near the critical pressure, which is quite distinct from the smooth curves at high temperatures (80 and 100 °C). Correspondingly, there are two "jump pressure" values in the density curves (30 and 55 °C) of the adsorption system and the density curves are divided into three stages. The Dubinin–Astakhov and Brunauer–Emmett–Teller (BET) models show an optimum degree of fit for CH4 and CO2 adsorption curves under all experimental temperature and pressure conditions. The Langmuir model fits the adsorption curves of 80 and 100 °C better, while the BET model is appropriate for 30 and 55 °C. The adsorption affinity of CO2 is higher than CH4, with the value of αCO2/CH4 in the range of 2.47–12.16. The value of αCO2/CH4 increases with a rise in pressure but is inhibited by high temperatures, while the inhibition is negligible when the experimental temperature exceeds 80 °C. The adsorption preferential of CO2 is stronger in the shallow reservoir (αCO2/CH4 > 10.5), and the application prospect of the EGR process is promising. In contrast, the adsorption preferential is slightly weakened in the deep reservoir (αCO2/CH4 < 4.5), which can be considered for CO2 capture, utilization, and storage. Results from this investigation provide novel insights on the adsorption characteristics of CH4 and CO2 on the shale matrix at high pressure and temperature. They are also expected to give certain enlightenment for the EGR–CCS process.This article has not yet been cited by other publications.

Comparation of Adsorption Properties of Pressure Swing Sorbents for Biogas

Performance Evaluation of Zn-Fe Adsorbent for H 2 S Adsorption During Biogas Purification

Pressure Swing Adsorption for Biogas Upgrading with Carbon Molecular Sieve

CO2 Adsorption by Polyamine-Based Protic Ionic Liquid-Functionalized Mesoporous Silica: Regenerability and Influence of Flue Gas Contaminants

Developing aqueous porous carbons for biogas upgrading

Comparison of carbon molecular sieve and zeolite 5A for CO2 sequestration from CH4/CO2 mixture gas using vacuum pressure swing adsorption

Experimental investigation of CO2 separation by adsorption methods in natural gas purification

Breakthrough analysis on selective adsorption of CO2 from biogas by polyethylenimine-impregnated resins

Optimization of a Six-Step Pressure Swing Adsorption Process for Biogas Separation on a Commercial Scale

Evaluation of the CH4/CO2 separation by adsorption on coconut shell activated carbon: Impact of the gas moisture on equilibrium selectivity and adsorption capacity

Biogas upgrading to fuel quality by dynamic adsorption of activated charcoal under non-isothermal conditions

Multicomponent adsorption measurements on activated carbon, zeolite molecular sieve and metal–organic framework

Characteristics of Activated Carbon in Elevated-Temperature Pressure Swing Adsorption Desulfurization

Porous Adsorption Materials for Carbon Dioxide Capture in Industrial Flue Gas

A New Composite Sorbent for Methane-Nitrogen Separation by Adsorption

Adsorption Characteristics of CH 4 and CO 2 in Shale at High Pressure and Temperature

High-pressure gas adsorption on activated carbons from pomegranate peels biochar: A promising approach for biogas purification

Solid Sorbents as a Retrofit Technology for CO2 Removal from Natural Gas Under High Pressure and Temperature Conditions

Biogas Upgrading to Methane: Application of a Regenerable Polyethyleneimine-Impregnated Polymeric Resin (NKA-9) Via CO2 Sorption

Comparison at laboratory scale of different types and configurations of commercial molecular sieves for one-step direct upgrading of biogas produced by anaerobic digestion

CO2 adsorption on Miscanthus × giganteus (MG) chars prepared in different atmospheres