Abstract:Biogas is an important renewable energy source, but its ppm-level hydrogen sulfide (H2S) component must be removed from the gas mixture dominated by CO2 and CH4. In this work, a tertiary-amine-based "molecular basket" sorbent with a mesoporous silica as support was found to be effective for the selective hydrogen sulfide (H2S) removal from gas mixtures simulating biogas,with a high CO2 concentration up to 40 vol %. Polyallylamine (PA), polyethylenimine (PEI), and tetramethyl hexanediamine (TMHDA) were used as primary, secondary, and tertiary amines to prepare the SBA-15 supported sorbents, respectively, and their H2S sorptipn performances were evaluated in a flow system in the absence and presence of CO2. The tertiary-amine-based sorbent, TMHDA/SBA-15, can selectively remove H2S in the presence of CO2, and the highest sorption capacity was achieved at 15 wt % TMHDA loading which is close to its monolayer coverage on the surface. More importantly, about 90% of the capacity could be maintained on TMHDA/SBA-15 even with the CO2 concentration as high as 40 vol %. The H2S sorption on TMHDA/SBA-15 fitted with the Langmuir adsorption isotherm well although the estimated adsorption heat with the van't Hoff equation is relatively low. Characterization using N-2 physisorption, FT-IR, and XPS demonstrated that the TMHDA is dispersed within the pore channels through the interaction between amine and silanol groups on the surface of SBA 15. The TMHDA/SBA-15 sorbents showed a good regenerability under a mild regeneration condition (e.g., 110 degrees C), the capacity of which was not impeded by other components in biogas such as CH4 and H2O.

Performance Evaluation of Zn-Fe Adsorbent for H 2 S Adsorption During Biogas Purification

Performance evaluation of Zn-Fe adsorbent for H2S adsorption during biogas purification

Microwave-assisted Synthesis of Zn-Fe Adsorbent Supported on Alumina: Effect of Zn to Fe Ratio on Syngas Desulfurization Performance

Review of high temperature H2S removal from syngas: Perspectives on downstream process integration

Adsorption Mechanism and Regeneration Performance of Calcined Zeolites for Hydrogen Sulfide and Its Application

Discovering the Interference of Hydrogen Sulfide on Polyethylenimine-Functionalized Porous Resin for Biogas Upgrading Via CO2 Adsorption

Hydrogen Sulfide Adsorption by Iron Oxides and Their Polymer Composites: A Case-Study Application to Biogas Purification

H2S Removal from Biogas using Steel Wool (Fe2O3) Adsorption Combined with Water Absorption: Experimental and Modelling via RSM

Review of high temperature H 2 S removal from syngas: perspectives on downstream process integration

Design and Performance of an Adsorption Bed with Activated Carbons for Biogas Purification

Experimental Study on the Treatment of Odor Gas Containing Hydrogen Sulfide by Immobilized Microorganisms

Selective Removal of H2S from Biogas Using Solid Amine-Based “molecular Basket” Sorbent

Self-assembled CuO-bearing Aerogel-Like Hollow Al2O3 Microspheres for Room Temperature Dry Capture of H2S

Low-temperature H2S Removal from Gas Streams with SBA-15 Supported ZnO Nanoparticles

Removal of H2S from biogas by adsorption with commercial activated carbon and granular iron oxide

Enhanced Biogas Purification Using Low-Cost Adsorption and Absorption Techniques

Comparison of adsorbents for H2S and D4 removal for biogas conversion in a solid oxide fuel cell

ZnFe2O4/activated Carbon As a Regenerable Adsorbent for Catalytic Removal of H2S from Air at Room Temperature

Synthesis of ZnO-CuO and ZnO-Co3O4 Materials with Three-Dimensionally Ordered Macroporous Structure and Its H2S Removal Performance at Low-Temperature

Effect of Bimetallic-Activated Carbon Impregnation on Adsorption–Desorption Performance for Hydrogen Sulfide (H2S) Capture

Support Features Govern the Properties of the Active Phase and the Performance of Bifunctional ZnFe2O4-based H2S Adsorbents