Breakthrough analysis on selective adsorption of CO2 from biogas by polyethylenimine-impregnated resins

Haiyan Yang,Yue Gong,Xinzhong Wang,Yuanyuan Chen,Dajiang Yu
DOI: https://doi.org/10.1007/s00396-024-05234-1
IF: 2.4
2024-03-27
Colloid & Polymer Science
Abstract:Polymer resin-based solid amine are prospective adsorbents used in removing CO 2 from biogas. Two commercial resins with different porous structures, AB-8 and ADS-17, were selected as supports to explore the influence of the support structures on adsorbent performance. It was discovered that macroporous channels greatly boost CO 2 adsorption at higher PEI loadings (≥ 30%), and their influence is more critical than total pore volume or specific surface area, though their impact is minimal at low PEI loadings. ADS-17-40% PEI demonstrated outstanding CO 2 adsorption of 208 mg·g −1 in its 16th cycle under specific operating conditions. Increasing gas flow rate to 200 mL·min −1 could promote CO 2 adsorption capacity and initial adsorption rate constant ( k 0 ) calculated by the deactivation model. The highest adsorption capacity was achieved at 55 °C, when the temperature ranged from 25 to 90 °C.
polymer science,chemistry, physical
What problem does this paper attempt to address?