Abstract:Miscanthus is a perennial rhizomatous grass and originates from the tropics and subtropics. The remarkable adaptability of miscanthus to different environments makes this novel crop suitable for establishment and distribution under a range of climatic conditions in China. Yields of Miscanthus have been reported to reach 30 t ha?1, thus it is considered as one of the most important potential biomass energy crops. To use miscanthus as the raw material to produce biogas, bio-oil and biochar are produced at the same time as by-products. Biochar is the charred byproduct of biomass pyrolysis, the heating of plant-derived material in the absence of oxygen in order to capture combustible gases. Its key characteristics are related to carbon sequestration. Due to its relative inertness, biochar contributes to the refractory soil organic carbon pool, and thus can decrease atmospheric CO2 concentrations by sequestering carbon when added to soil. Therefore, applying biochar to soil may contribute to decreasing, or slowing the increase in, global warming. In addition, it can be used as a soil conditioner, not only having potential in improving soil fertility, but also in remediating polluted soil. So far, we have understood little about miscanthus biochar, which becomes a bottleneck for applying the biochar as a soil conditioner. In this paper, miscanthus giganteus straw was dried at 105°C for 24 h, milled to<1 mm, and pyrolysed in a Carbolite CWF 1 200 furnace with a sealable retort (Carbolite, Hope, UK), flushed with argon. The furnace was initially heated to 100°C. The temperature then increased to 350 (BC350) or 700°C (BC700) at 1°C min?1, and finally held at 350 or 700°C for 30 min. The resulting biochars were subsequently cooled to room temperature overnight, while maintaining the argon flush, and were collected and then their characteristics were determined with different methods. The aim was to investigate the nature of the biochar and its changes with temperature. The results showed that the physio-chemical properties of the biochar were largely determined by the carbonization temperature. The miscanthus biochar produced at 350℃ (BC350) contained more water-soluble components, indicating it giving higher soil fertility if applied in soil. For example, as biochar was added to soil at application rates equivalent to 5%of total soil organic C, this gave 222 and 16 μg water-extractable C g-1 soil for biochar350 and biochar700, respectively. The latter C concentration is clearly negligible. The same trend was found for NH4+-N, but on a much smaller scale: 1.75 and 0.18 μg NH4+-N g-1 biochar, equivalent to 0.09 and 0.01 μg N g-1 soil, for biochar350 and biochar700, respectively. BC700 had higher pH, C/N ratio, water-holding capacity (WHC), and surface area. Theδ13C value, however, showed no difference between BC350 and BC700, while extractable NO3?-N was not detected in the water extracts from both biochars. The paper also discussed the potential value and its prospects of industrial application of miscanthus biochar, with current biochar producing equipment development, in improving soil fertility, soil remediation, and water purification in China.

CO2 adsorption on Miscanthus × giganteus (MG) chars prepared in different atmospheres

Regenerable MgO-based Sorbents for CO2 Capture at Elevated Temperature and Pressure: Experimental and DFT Study

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Developing a Novel CaO-Based Sorbent for Promoted CO2 Capture and Tar Reduction

Kinetic study on the CO2 gasification of biochar derived from Miscanthus at different processing conditions

Carbon Dioxide Capture with Polyethylenimine-Functionalized Industrial-Grade Multiwalled Carbon Nanotubes

Fabrication Of A New Mgo/C Sorbent For Co2 Capture At Elevated Temperature

Adsorption and Regeneration Study of Polyethylenimine-Impregnated Millimeter-Sized Mesoporous Carbon Spheres for Post-Combustion CO2 Capture

Microwave-induced preparation of MgO-loaded N-rich porous biochar from marine biomass for efficient CO2 capture and mechanism exploration via theoretical calculation

Renewable biochar derived from mixed sewage sludge and pine sawdust for carbon dioxide capture

Mesoporous Carbon Stabilized MgO Nanoparticles Synthesized by Pyrolysis of MgCl2 Preloaded Waste Biomass for Highly Efficient CO2 Capture.

Acquiring an Efficient Warm‐CO2 Sorbent from Advanced Pyrolysis of Magnesium Oxalate

Studies of CO2 gasification of the Miscanthus giganteus biomass over Ni/Al2O3-SiO2 and Ni/Al2O3-SiO2 with K2O promoter as catalysts

Insights into CO2 adsorption on KOH-activated biochars derived from the mixed sewage sludge and pine sawdust

Adsorption Characteristics of Gas Molecules (H2O, CO2, CO, CH4, and H2) on CaO-Based Catalysts during Biomass Thermal Conversion with in Situ CO2 Capture

Adsorption of Co2, Ch4, and N-2 on Ordered Mesoporous Carbon: Approach for Greenhouse Gases Capture and Biogas Upgrading

Molecular Simulation Combined with DFT Calculation Guided Heteroatom-Doped Biochar Rational Design for Highly Selective and Efficient CO2 Capture

Direct CO2 capture from air using char from pyrolysis of digestate solid

Biomass Thermochemical Conversion Via Pyrolysis with Integrated CO2 Capture

Ultrafast and Stable CO 2 Capture Using Alkali Metal Salt-Promoted MgO-CaCO 3 Sorbents.

Physio-chemical Characterization of Biochars Pyrolyzed from Miscanthus under Two Different Temperatures