Abstract:Fermi-level pinning (FLP) effect was widely observed in thin-film transistors (TFTs) with van der Waals (vdW) layered semiconductors (organic or two-dimensional) when contact electrodes were thermally evaporated1-3. Intensive investigation was implemented for formation of FLP-free interfacial states by eliminating chemical disorder and crystal defects arising from metal deposition4-9. However, technical and principal challenges are still existing towards high-yield, wafer-scalable and low-cost integration of TFT devices. Herein, we developed a general, scaling-up strategy to fabricate large-scale, high-performance FLP-free organic TFT (OTFT) arrays by using printed vdW contacts consisting of MXene composite electrodes and 2, 7-dioctyl [1] benzothieno [3, 2-b] [1] benzothiophene (C8BTBT). Room-temperature processes allow for a physically stacked junction without any structural or chemical damages. The OTFT arrays can be printed on a large-area silicon wafer or plastic film with 100% yield, exhibit ultrahigh field-effect mobility ({\mu}_FE) over 17.0 square centimetres per volt per second (cm2 V-1s-1), high on/off ratio exceeding 108, relatively low contact resistance of 3k ohm micrometres. The underlying mechanism for the high device performance was unveiled by Kelvin Probe Force Microscopy (KPFM) combined with theoretical simulation. The results indicate that work function (W_F) of the printed electrodes can be tuned at a wide range of 4.8-5.6 eV, thus significantly lowering the charge-injection barrier at the contact interfaces with ideal FLP-free character (the interfacial factor reaches 0.99 \pm 0.02). This study paves a general strategy for achieving large-scale, high-performance thin-film electronics.

Mechanical Strain and Temperature Optimization for Thin-Film Transistor Based Pseudo-CMOS Logic Array

Mechanical Strain and Temperature Aware Design Methodology for Thin-Film Transistor Based Pseudo-Cmos Logic Array.

Design Methodology for TFT-Based Pseudo-CMOS Logic Array with Multilayer Interconnection Architecture and Optimization Algorithms

Design Methodology for Thin-Film Transistor Based Pseudo-CMOS Logic Array with Multi-Layer Interconnect Architecture.

Strain Optimization in Silicon P-Type Double-Gate MOSFET at 7nm Channel Length

Optimized Optical Design of Thin-Film Transistor Arrays for High Transmittance and Excellent Chromaticity

Aging-Aware LTPO DTCO for Large-Scale Integrated Circuit-Driven Flexible Intelligent Sensing System

Highly Scalable and Robust Mesa‐Island‐Structure Metal‐Oxide Thin‐Film Transistors and Integrated Circuits Enabled by Stress‐Diffusive Manipulation

Temperature Dependent Anomalous Threshold Voltage Modulation of a-IGZO TFT by Incorporating Variant Gate Stresses

Current Temperature Stress Induced Threshold Degradation on Corbino A-Ingazno Transistors

50‐4: Invited Paper: Low‐Temperature Metal‐Oxide Thin‐Film Transistor Technology and the Realization of Electronic Systems on Flexible Substrates

Sub-Micron Oxide TFT for the Era of Oxide-Based Display

Fabrication optimization to improve performance of gallium-doped zinc oxide thin film transistors

Comprehensive Stress Effect of Thin Coatings and Silicon-Carbon Lattice Mismatch on Nano-Scaled Transistors with Protruding Poly Gate

Thermal Budget Reduction in Metal Oxide Thin-Film Transistors via Planarization Process

Strain-Induced Performance Variation in Stretchable Carbon-Nanotube Thin-Film Transistors and the Solution Through a Circular Channel Design

High-Yield, Scaling-Up Fabrication of Fermi-Level-Pinning-Free Organic Thin-Film Transistor Arrays with Printed Van der Waals Contacts

Addressing the Conflict between Mobility and Stability in Oxide Thin‐film Transistors

Enhancing Repetitive Uniaxial Mechanical Bending Endurance at <inline-formula> <tex-math notation="LaTeX">${R} = 2$ </tex-math></inline-formula> mm Using an Organic Trench Structure in Foldable Low Temperature Poly-Si Thin-Film Transistors

Highly-Doped Region Optimization for Reduced Hot-Carrier Effects in Dual-Gate Low Temperature Polysilicon TFTs

P‐17: Design of AMOLED Pixel Circuit Using LTPO TFTs with Enhanced Reliability