Abstract:Methanol to aromatics (MTA) following dual cycles concept unavoidably produced considerable amounts of olefinic intermediates and paraffinic by-products. Their formation and further conversion were vital to improving aromatics production. In this study, a two-stage fluid bed packed with fluid Zn/ZSM-5 catalyst in each stage was used to investigate the MTA reaction at 470 degrees C in the first stage and the secondary conversion of MTA primary products at temperatures from 270 degrees C to 550 degrees C in the second stage with time on stream. During the MTA reaction, the decrease of catalyst acidity was beneficial to controlling hydrogen transfer, thus blocking propane formation. During the secondary conversion of MTA products, at temperatures below 390 degrees C, the alkylation and hydrogen transfer reactions dominated and thus olefins were converted into more alkylbenzene as well as the undesired propane and butane. As the temperature increased from 430 degrees C to 550 degrees C, the aromatization of light hydrocarbon and the dealkylation of alkylbenzene were facilitated, producing more benzene and toluene but increasing methane and ethane yields. Meanwhile, the dehydrogenation and cracking of propane and butane were favored by high temperature and strong acidity so that the yields of ethene and propene increased. It was clarified that the characteristics of secondary conversion of MTA products varied and depended on reaction temperature and catalyst acidity. Based on these findings, the concept of regional functionalization of fluidized bed reactor was proposed for intensification of MTA process based on the reconfiguration of the temperature and acidity of catalyst stream during the fluidized bed reaction-regeneration cycle.

Temperature-dependent Secondary Conversion of Primary Products from Methanol Aromatization in a Two-Stage Fluidized Bed

Efficient Conversion of Methane to Aromatics in the Presence of Methanol at Low Temperature

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

A Multi-Stage Fluidized Bed Strategy for the Enhanced Conversion of Methanol into Aromatics

Study on in-situ catalytic conversion of alcohols to aromatics and its mechanism

High-yield Production of Aromatics from Methanol Using a Temperature-Shifting Multi-Stage Fluidized Bed Reactor Technology

Enhancing Low-Temperature Methane Conversion on Zn/ZSM-5 in the Presence of Methanol by Regulating the Methanol-to-aromatics Reaction Pathway

Thermodynamic Analysis of Propane Aromatization

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Conversion of Methanol with C5–C6 Hydrocarbons into Aromatics in a Two-Stage Fluidized Bed Reactor

Decentralized Methanol Feed in a Two-Stage Fluidized Bed for Process Intensification of Methanol to Aromatics

Tandem Aromatization of Pentane with Temperature Shifting Three-Stage Fluidized Bed Reactor

Methane Aromatization in Fluidized Bed Reactor

Conversion of methanol to aromatics in fluidized bed reactor

Methane Aromatization in a Fluidized Bed Reactor: Parametric Study

Influence of Catalyst Acidity on Dealkylation, Isomerization and Alkylation in Mta Process

Pt3Mn/SiO2 + ZSM-5 Bifunctional Catalyst for Ethane Dehydroaromatization

Study on direct aromatization reaction of methane: I. The reaction performance of supported Mo catalysts under oxygen-free conditions

Enhanced Production of Aromatics from Propane with a Temperature-Shifting Two-Stage Fluidized Bed Reactor.

Catalytic conversion of C4 fraction for the production of light olefins and aromatics

Selective Conversion of Syngas into Tetramethylbenzene Via an Aldol-Aromatic Mechanism