Abstract:The activities of the cobalt and zinc-impregnated HZSM-5 catalysts to the non-oxidative conversion of propane (C3) and methane (C1) into aromatic hydrocarbons were evaluated using a fixed-bed microreactor. C1 conversion reached 36.7% and the selectivity of aromatic products reached above 88.7% at atmospheric pressure, weight (hourly) space velocity (WHSV) 1.6 g h−1/(g cat)−1 and 873 K. The influence of the acidity and the ratio of cobalt in the catalyst on the conversion of methane and propane was evaluated. C1 incorporation was conclusively confirmed by the mass spectral analyses of aromatic products produced in a run with 13CH4 which shows a significant 13C enrichment in the C6H6+, C7H8+ and C8H10+ fragments. The methane activation could result from its hydrogen-transfer reaction with alkenes. These catalysts were thoroughly characterized using XRD, N2 adsorption measurements, TPD of NH3, and FT-IR. The results showed that the activation of methane in low temperature was due to existence of propane. The acidic changes and micropore area of the catalyst severely affected aromatization, and resulted in drastic modifications in product distribution. From this work, we found that only a small fraction of tetrahedral framework aluminum, which corresponds to the Bronsted acid sites, is sufficient to accomplish the aromatization of the intermediates in methane and propane aromatic reaction, while the superfluous strong Bronsted acid sites, which can be decreased by adding Co and Zn, are showed to be related with the aromatic carbonaceous deposits on the catalysts. The density of acidic site and the strength of strong acid decreased when the concentration of Co and Zn in the catalyst increased. Therefore, a much higher benzene yield and a longer durability of the catalysts are obtained when compared with the conventional HZSM-5 catalysts.

Methane Aromatization in Fluidized Bed Reactor

Methane Aromatization in a Fluidized Bed Reactor: Parametric Study

Efficient Conversion of Methane to Aromatics in the Presence of Methanol at Low Temperature

Conversion of methanol to aromatics in fluidized bed reactor

Thermodynamic Analysis of Propane Aromatization

Conversion of Methanol with C5–C6 Hydrocarbons into Aromatics in a Two-Stage Fluidized Bed Reactor

Temperature-dependent Secondary Conversion of Primary Products from Methanol Aromatization in a Two-Stage Fluidized Bed

Study on direct aromatization reaction of methane: I. The reaction performance of supported Mo catalysts under oxygen-free conditions

Methane Dehydroaromatization over Mo/HZSM-5: A Study of Catalytic Process

Comparative Study Between Fluidized Bed and Fixed Bed Reactors in Methane Reforming with CO2 and O2 to Produce Syngas

Methanol Production in Fluidized Bed Reactor Using Different Catalysts

Nonoxidative Coupling of Methane to Olefins and Aromatics over Molten W-In Bimetal Catalyst

Recent Progress in Methane Dehydroaromatization: from Laboratory Curiosities to Promising Technology

Gas to Liquids: Natural Gas Conversion to Aromatic Fuels and Chemicals in A Hydrogen-Permeable Ceramic Hollow Fiber Membrane Reactor

High-yield Production of Aromatics from Methanol Using a Temperature-Shifting Multi-Stage Fluidized Bed Reactor Technology

Production of Methanol in Fluidized Bed Reactor

Remarkable Improvement on the Methane Aromatization Reaction: A Highly Selective and Coking-Resistant Catalyst

Bubble dynamics and thermochemical characteristics of bubbling fluidized bed methanation

A Multi-Stage Fluidized Bed Strategy for the Enhanced Conversion of Methanol into Aromatics

Numerical Simulation of CO Methanation for the Production of Synthetic Natural Gas in a Fluidized Bed Reactor

Aromatization of Methane by Using Propane As Co-Reactant over Cobalt and Zinc-Impregnated HZSM-5 Catalysts