Abstract:Hydrogen gas is an ideal fuel due to its higher calorific value among fuels and minimal environmental impact on their energy applications. However, the high cost around high reactivity, explosion risks and extremely low energy density, make it unfeasible to be used as fuel in large quantities scale. There are some possibilities to circumvent these limitations, including obtaining and converting energy through fuel cells, which is very promising. Research in this field has been summarized in recent decades, motivated by the environmental problems faced due to the dependence on non-renewable energy matrices. From this, this study aimed to improve the steam methanol reforming using CuO/ZnO/Al2O3 catalyst. The catalyst was characterized by atomic absorption spectroscopy, N2 physisorption and XRD. Catalytic tests were carried out in a laboratory scale fixed bed reactor at 300°C, atmospheric pressure and in differential conditions (methanol conversion < 10%); a previous run for catalyst synthesis validation in relation to the results obtained in the literature for the same conditions was evaluated. Subsequently, it was found that the thermal degradation of methanol at 300°C without the presence of the catalyst was negligible, and then operational conditions were established to obtain methanol conversions lower than 10%. Then, the initial deactivation of the catalyst over 31h. Also identifying the stability after 7 h in reaction with average conversion into 9.7% of methanol, showing high stability, in addition to good reproducibility on the part of synthesis in optimal composition. Then, experiments were carried out for the molar ratios 2:1 and 4:1 with methanol conversions of 15.5% and 6.6%, respectively. Note that performing the average of the 4:1 and 2:1 methanol conversion in 14.6% obtained at indicating that the upper boundary molar ratios (4:1) compensates for the conversion reduction in 2:1, achieving a result superior to the reference 3:1.

Methanol Production in Fluidized Bed Reactor Using Different Catalysts

Methanol Synthesis from CO 2 and H 2 over Pd/ZnO/Al 2 O 3 : Catalyst Structure Dependence of Methanol Selectivity

Cu-Zr-Zn catalysts for methanol synthesis in a fluidized bed reactor

Production of Methanol in Fluidized Bed Reactor

Preparation of Cu-based Catalysts for Methanol Synthesis in a Fluidized Bed Reactor and Their Performance

Methanol Synthesis in Three-phase Agitated Reactor Using C302-2 Catalyst I. Influence of Operating Conditions on Methanol Synthesis

Experimental and kinetic modelling studies for the design of fixed bed methanol reactor over CuZA catalyst

Effective Cu/ZnO/Al2O3 Catalyst for Methanol Production: Synthesis, Activation, Catalytic Performance, and Regeneration

Production of Synthetic Natural Gas by CO Methanation over Ni/Al2O3 Catalyst in Fluidized Bed Reactor

Methanol Synthesis from CO2 Hydrogenation with a Cu/Zn/Al/Zr Fibrous Catalyst

Kinetics of Methanol Synthesis from Carbon Dioxide Hydrogenation over Copper–Zinc Oxide Catalysts

Absorption Enhanced Methanol Synthesis in a Trickle Bed Reactor over Cu/Zn/Al2O3 Catalyst

Performance analysis of methanol to olefins process in fluidized bed reactor

Evaluation of feeding molar rate in mini fixed bed reactor for methanol steam reforming with pre-optimized composition of CuO/ZnO/Al2O3 catalyst

Fe–Ni–Ce–Zr-modified CuO–ZnO catalyst for methanol steam reforming

Characteristics of the Synthesis of Methanol Using Biomass-Derived Syngas

Methane Aromatization in Fluidized Bed Reactor

Conversion of Methanol with C5–C6 Hydrocarbons into Aromatics in a Two-Stage Fluidized Bed Reactor

Cu/ZnAl2O4 Catalysts Prepared by Ammonia Evaporation Method: Improving Methanol Selectivity in CO2 Hydrogenation Via Regulation of Metal-Support Interaction

High-Performance Cu/ZnO/Al 2 O 3 Catalysts for CO 2 Hydrogenation to Methanol