Abstract:Dimethyl ether (DME) is regarded as an environmentally benign fuel for vehicles. Two kinds of reactor technologies for DME synthesis have been proposed by previous researchers: the fixed-bed and the slurry reactor. As the reactions are highly exothermic and the temperature window of the catalyst is very narrow, the fixed-bed reactor provides a limited heat removal capability and a low conversion of the syngas. The slurry reactor can provide an effective temperature control but a very high inter-phase mass transfer resistance is added by the liquid medium. The Fluidized bed reactor can be an ideal reactor for DME synthesis as it possesses both high heat and mass transfer efficiencies. In this paper, a two-phase model is used to theoretically analyze the DME synthesis in a fluidized bed reactor, with both phases assumed to be in plug flow and taking into account the changes in bubble diameter resulting from the reaction. Three reactions take place simultaneously when DME is manufactured from the syngas (H2 + CO): a) CO+2H2 = CH3OH; b) 2CH3OH = DME+H2O; and c) CO+H2O = CO2+H2. The simulation shows that, at the reactor outlet, the equilibrium approaches of the three reactions are 0.32, 0.1, and 0.61, respectively. When H2/CO=1.0, the CO conversion and DME selectivity in a fluidized bed reactor are 62% and 95%, while those in a fixed-bed reactor are 9% and 86%. In a slurry reactor, the CO conversion and DME selectivity are 17% and 70%, respectively. Therefore, the fluidized-bed is the most promising candidate reactor for conducting the DME synthesis from syngas. Effects of the operating conditions on the performance of DME synthesis in the fluidized-bed reactor are discussed in details. The optimal H2/CO ratio is between 1.0-1.5, and increasing the pressure is shown to improve the reactor performance.

Production of Methanol in Fluidized Bed Reactor

Simulation of Fluidized Bed Reactor for Methanol to Olefins(MTO)Process

Methanol Production in Fluidized Bed Reactor Using Different Catalysts

Simulation of multi-fluidized-bed in series for methanol to olefins

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Performance analysis of methanol to olefins process in fluidized bed reactor

Methanol to Propylene Process in a Moving Bed Reactor with Byproducts Recycling: Kinetic Study and Reactor Simulation

Numerical Simulation of CO Methanation for the Production of Synthetic Natural Gas in a Fluidized Bed Reactor

Methanol production by CO2 hydrogenation: Analysis and simulation of reactor performance

Theoretical Analysis of Fluidized-Bed Reactor for Dimethyl Ether Synthesis from Syngas

Process simulation of methanol production via carbon dioxide hydrogenation

Conversion of methanol to aromatics in fluidized bed reactor

Methane Aromatization in Fluidized Bed Reactor

Production of Synthetic Natural Gas by CO Methanation over Ni/Al2O3 Catalyst in Fluidized Bed Reactor

Comparative Study Between Fluidized Bed and Fixed Bed Reactors in Methane Reforming with CO2 and O2 to Produce Syngas

Numerical Investigation on Methanation Kinetic and Flow Behavior in Full-Loop Fluidized Bed Reactor

Study on Effective Radial Thermal Conductivity of Gas Flow Through A Methanol Reactor

Experimental and kinetic modelling studies for the design of fixed bed methanol reactor over CuZA catalyst

Conversion of Methanol with C5–C6 Hydrocarbons into Aromatics in a Two-Stage Fluidized Bed Reactor

Research Progress in Fluidized Bed Methanation Technology

Characteristics of the Synthesis of Methanol Using Biomass-Derived Syngas