Abstract:Methanol to aromatics (MTA) following dual cycles concept unavoidably produced considerable amounts of olefinic intermediates and paraffinic by-products. Their formation and further conversion were vital to improving aromatics production. In this study, a two-stage fluid bed packed with fluid Zn/ZSM-5 catalyst in each stage was used to investigate the MTA reaction at 470 degrees C in the first stage and the secondary conversion of MTA primary products at temperatures from 270 degrees C to 550 degrees C in the second stage with time on stream. During the MTA reaction, the decrease of catalyst acidity was beneficial to controlling hydrogen transfer, thus blocking propane formation. During the secondary conversion of MTA products, at temperatures below 390 degrees C, the alkylation and hydrogen transfer reactions dominated and thus olefins were converted into more alkylbenzene as well as the undesired propane and butane. As the temperature increased from 430 degrees C to 550 degrees C, the aromatization of light hydrocarbon and the dealkylation of alkylbenzene were facilitated, producing more benzene and toluene but increasing methane and ethane yields. Meanwhile, the dehydrogenation and cracking of propane and butane were favored by high temperature and strong acidity so that the yields of ethene and propene increased. It was clarified that the characteristics of secondary conversion of MTA products varied and depended on reaction temperature and catalyst acidity. Based on these findings, the concept of regional functionalization of fluidized bed reactor was proposed for intensification of MTA process based on the reconfiguration of the temperature and acidity of catalyst stream during the fluidized bed reaction-regeneration cycle.

Catalytic conversion of C4 fraction for the production of light olefins and aromatics

Enhanced Reaction Performances For Light Olefin Production From Butene Through Cofeeding Reaction With Methanol

Study on Thermodynamics of Butene Catalytic Cracking to Propene and Ethene

Study on in-situ catalytic conversion of alcohols to aromatics and its mechanism

Study on Production of Propylene from C4 Olefins by Catalytic Cracking

Combined dealkylation and transalkylation reaction in FCC condition for efficient conversion of light fraction light cycle oil into value-added products

Effects of operational conditions on butene oligomerization over HZSM-5

THERMODYNAMICS ANALYSIS AND REACTION PERFORMANCE OF THE PRODUCTION OF PROPYLENE AND ETHYLENE FROM C4OLEFINS CRACKING

Modulated hydrocarbon distribution of gasoline deriving from butene conversion in the presence of syngas

Selective conversion of bio-oil to light olefins: Controlling catalytic cracking for maximum olefins

Catalytic Cracking of Lower-Valued Hydrocarbons for Producing Light Olefins

Catalytic Cracking of Butene to Ethylene and Propylene over SAPO 34 Molecular Sieves

Aromatization Reactions of Three Gasoline Fractions

Cracking Performance and Feed Characterization Study of Catalytic Pyrolysis for Light Olefin Production

Temperature-dependent Secondary Conversion of Primary Products from Methanol Aromatization in a Two-Stage Fluidized Bed

Hexene Catalytic Cracking over 30% Sapo-34 Catalyst for Propylene Maximization: Influence of Reaction Conditions and Reaction Pathway Exploration

Selective conversion of CO2 to isobutane-enriched C4 alkanes over InZrOx-Beta composite catalyst

THE REACTION PATHS OF CHARACTERISTIC PRODUCTS FROM MONOMOLECULAR AND BIMOLECULAR CRACKING REACTION OF HEAVY FRACTIONS OF FCC GASOLINE II.The Formation Paths of Characteristic Products over Different Type Catalysts

Catalytic conversion of bio-oil to oxygen-containing fuels by simultaneous reactions with 1-butanol and 1-octene over solid acids: Model compound studies and reaction pathways

Kinetics of Coupling Cracking of Butene and Pentene on Modified HZSM-5 Catalyst

Cleanup and Conversion of Biomass Liquefaction Aqueous Phase to C3–C5 Olefins over ZnxZryOz Catalyst