Abstract:The thermal and catalytic cracking of Arabian Light crude oil, which has a density of 34° API, were evaluated in a fixed-bed microactivity test (MAT) unit between 550 and 650 °C. For the catalytic cracking, two catalysts were used, a steamed commercial MFI catalyst (M-cat) and an equilibrium FCC catalyst (E-cat). Thermal and catalytic cracking were compared at the same conversion, 34%, at 650 °C. For both, as the temperature increased, the yields of light olefins, LPG, dry gas, and coke increased, associated with a consistent decrease in heavy ends (LCO and HCO). The naphtha yield for catalytic cracking decreased as temperature increased; however, for thermal cracking, it was nearly constant. The superiority of catalytic cracking over thermal cracking for the propylene yield was interpreted in terms of mechanisms of free radicals and carbenium ions. Thermal cracking gave a higher yield of ethylene. At high temperature (650 °C) and catalyst to oil (C/O) ratio of 4, the olefins yield decreased in the order of M-cat (32.7 wt %) > E-cat (30.3 wt %) > thermal cracking (22.8 wt %). The highest yields of ethylene and propylene (10.9 and 15.7 wt %), achieved over M-cat at 650 °C, are attributed to shape selectivity and higher acidity. The naphtha yield for E-cat was much higher than for M-cat; for instance, at 550 °C it was 48.3 wt % for E-cat and 24.4 wt % for M-cat. This was attributed to diffusion limitations for M-cat. The effect of the C/O ratio on conversion and yields was also inspected, and the analysis showed that after a C/O ratio of 4, further increases had only a minor effect. Lastly, the effect of mixing E-cat and M-cat at different percentages was evaluated, and the investigation showed an optimum point at 58% M-cat, with the corresponding yields of ethylene and propylene at 10.7 and 19.2 wt %, respectively.

Conversion of Arabian Light Crude Oil to Light Olefins via Catalytic and Thermal Cracking

Catalytic Cracking of Light Crude Oil to Light Olefins and Naphtha over E-Cat and MFI: Microactivity Test versus Advanced Cracking Evaluation and the Effect of High Reaction Temperature

Catalytic Cracking of Arab Super Light Crude Oil to Light Olefins: An Experimental and Kinetic Study

Catalytic cracking of crude oil to light olefins and naphtha: Experimental and kinetic modeling

Catalytic Cracking of Light Crude Oil: Effect of Feed Mixing with Liquid Hydrocarbon Fractions

Low-Temperature-Initiated Cracking of Hydrocarbons to Produce Olefins: Simulation and Comparison of Different Initiators

Efficient processing of crude oil using direct cracking at high temperatures over modified FCC catalysts

Catalytic Cracking of Crude Oil: Mini Review of Catalyst Formulations for Enhanced Selectivity to Light Olefins

Cracking Performance and Feed Characterization Study of Catalytic Pyrolysis for Light Olefin Production

Thermal/catalytic cracking of hydrocarbons for the production of olefins: A state-of-the-art review I: Thermal cracking review

Thermal/catalytic cracking of liquid hydrocarbons for the production of olefins: A state-of-the-art review II: Catalytic cracking review

Enhancing the production of light olefins from heavy crude oils: Turning challenges into opportunities

Catalytic Cracking of Lower-Valued Hydrocarbons for Producing Light Olefins

Catalytic cracking of heavy atmospheric gas oil to light olefins over ZSM-5 zeolite: Effect of crystal size in the absence/presence of steam

Cracking Performance of Gasoline and Diesel Fractions from Catalytic Pyrolysis of Heavy Gas Oil Derived from Canadian Synthetic Crude Oil

Maximization production of light olefins from dual-stage catalytic dehydrogenation cracking of crude oil: Catalysis mechanism and pilot trial

Steam catalytic cracking and lump kinetics of naphtha to light olefins over nanocrystalline ZSM-5 zeolite

One-step conversion of crude oil to light olefins using a multi-zone reactor

Catalytic conversion of C4 fraction for the production of light olefins and aromatics

Nano BEA zeolite catalysts for the selective catalytic cracking of n-dodecane to light olefins