Abstract:A new theory of designing dual-band power divider (PD) based on Wilkinson structure is presented in this paper. Because of the utilization of coupled lines, the proposed PD is with a high design freedom that many transmission line (TL) combinations can be used for a fixed frequency ratio k (f(2)/f(1)). Meanwhile, since the lengths of the conventional coupled lines used are extremely long, the slow-wave structure is introduced, which configuration results in a property of designable length and compact size because of the improved space efficiency. After analysing the even- and odd-mode circuits, precise design formulas are derived and further verified for the frequency ratio from 1.5 to 6.0 using NI AWR simulator under the consideration of the largest realizable TL impedance as 128 Omega. For verification, two PDs with the same centre frequency of 1.0 GHz and 4.0 GHz but different TL configurations are designed based on the proposed design theory. According to the experimental results, both fabricated PDs have good performances as expected, such as low in-band insertion loss (S-21), wide isolation, and relatively better out-of-band rejection than majority of previous studies that the maximum S-21 between the two passbands is larger than 6 dB, while previous studies are around 4 dB.

Wilkinson Filtering Power Divider Using Coupled Lines and T‐shaped Stub

Wideband Four-Way Filtering Power Divider with Isolation Performance Using Three Parallel-Coupled Lines

Design of Wideband Filtering Power Dividers with Harmonic Suppression Based on the Parallel-Coupled Line Structures

Design of A Compact Wilkinson Power Divider with High Order Harmonics Suppression

Design Method of Dual-Band Wilkinson Power Divider with Designable Length and High Design Freedom

Dual-Band Filtering Power Divider Using Dual-Resonance Resonators with Ultrawide Stopband and Good Isolation

A 10:1 Unequal Wilkinson Power Divider Using Coupled Lines with Two Shorts

A tri-band Wilkinson power divider using extended T-shaped stubs

A New Quad-Band Wilkinson Power Divider

Design of Filtering Power Divider with High Frequency Selectivity

A Novel Wideband Filtering Power Divider With Embedding Three-Line Coupled Structures.

High-performance filtering power divider with multiple transmission zeros

Wideband Filtering Power Divider with Deep and Wide Stopband

A dual-band Wilkinson power divider with 6:1 power dividing ratio using coupled lines

Design of a Wideband Filtering Power Divider with Good In‐band and Out‐of‐band Isolations

Filtering Power Divider with Wide Stopband Using Open-Stub Loaded Coupled-Line and Hybrid Microstrip T-Stub/DGS Cell

A Dual-Band Wilkinson Power Divider Using Dual Coupled Lines and Open Stubs

Wideband Power Divider Using Gysel and Modified Wilkinson Structure.

Exact synthesis of couple‐line based wideband four‐way filtering power divider with unequal power division

Analysis and design of a novel coupled-line wideband Wilkinson power divider

Wideband three-way power divider with bandpass filtering response using unequal-width three-coupled line