Abstract:For the fabrication of high-strength carbon nanotube (CNT) reinforced Al matrix composites, the uniform dispersion, strong interface bonding and high structural integrity of CNTs have been regarded as the three most important issues. In this work, two distinct approaches, namely high shear dispersion (HSD) and shift-speed ball milling (SSBM), were applied to disperse CNTs (1.5 wt%) into pure Al powders. These two kinds of CNT/Al composite powders as well as the pure Al powder (as a comparison) were deposited onto stainless steel plates by cold spraying using different processing parameters. The velocity and the temperature of the particle prior to impact was simulated by the commercial code of Fluent. The deposition efficiency, microstructure evolution, as well as the distribution and structural integrity of CNTs in the composite coatings produced from different starting powders were comparatively investigated in terms of X-ray diffraction (XRD), Raman spectra, and electron back scanning diffraction (EBSD). According to the XRD and Raman analysis, no new phases such as oxides or brittle Al4C3 were detectable in both CNT/Al composite coatings. Some structural damages of CNTs were found in both composite coatings, especially the one fabricated from HSD composite powder. The dispersion of CNTs onto Al particle surfaces by HSD approach did not achieve a significant strengthening effect on the composite coatings, but adversely affected the metallic bonding of the particles and the substrate. The microhardness of the CNT/Al composite coating produced from SSBM powders reached around ~115 HV0.1, showing a significant improvement compared to the pure Al coating mainly due to the grain refinement and CNTs strengthening.

Tailoring and Characterization of Carbon Nanotube Dispersity in CNT/6061Al Composites

Reducing Dispersity of Mechanical Properties of Carbon Fiber/epoxy Composites by Introducing Multi-Walled Carbon Nanotubes

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Synthesis of carbon nanotube reinforced Al matrix composite coatings via cold spray deposition

Study on the Mechanism of CNTs Regulating the Microstructures and Properties of Al–Cu–Mg Alloy

Carbon Nanotubes: Intragranular Dispersion of Carbon Nanotubes Comprehensively Improves Aluminum Alloys (adv. Sci. 7/2018)

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

Mechanical properties of CNT-reinforced Ni3Al composites: the role of chirality, temperature, and volume fraction

Smart Mechanical Powder Processing for Producing Carbon Nanotube Reinforced Aluminum Matrix Composites

Unraveling the dispersion mechanism of carbon nanotubes in aluminum powder particles during high energy ball milling by FIB-TEM study

Effect of CNT dispersion methods on the strength and fracture mechanism of interface in epoxy adhesive/Al joints

Interfacial modification of carbon fiber by carbon nanotube gas-phase dispersion

Effect of Carbon Nanotubes as Reinforcement on the Mechanical Properties of Aluminum-Copper-Magnesium Alloy

Investigation on the Microstructure and Mechanical Properties of CNTs-AlSi10Mg Composites Fabricated by Selective Laser Melting

Fabrication and Tribological Properties of Carbon Nanotubes-Aluminum Composites

Effect of Carbon Nanotube Orientation on Mechanical Properties and Thermal Expansion Coefficient of Carbon Nanotube-Reinforced Aluminum Matrix Composites

Improving the mechanical properties of carbon nanotubes reinforced pure aluminum matrix composites by achieving non-equilibrium interface

Enhanced strain hardening by bimodal grain structure in carbon nanotube reinforced Al–Mg composites

Interface enhancement of carbon nanotube/mesocarbon microbead isotropic composites

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy

Investigation of Microstructure and Strengthening Mechanism in CNTs Reinforced Mo-based Composites