Abstract:For the fabrication of high-strength carbon nanotube (CNT) reinforced Al matrix composites, the uniform dispersion, strong interface bonding and high structural integrity of CNTs have been regarded as the three most important issues. In this work, two distinct approaches, namely high shear dispersion (HSD) and shift-speed ball milling (SSBM), were applied to disperse CNTs (1.5 wt%) into pure Al powders. These two kinds of CNT/Al composite powders as well as the pure Al powder (as a comparison) were deposited onto stainless steel plates by cold spraying using different processing parameters. The velocity and the temperature of the particle prior to impact was simulated by the commercial code of Fluent. The deposition efficiency, microstructure evolution, as well as the distribution and structural integrity of CNTs in the composite coatings produced from different starting powders were comparatively investigated in terms of X-ray diffraction (XRD), Raman spectra, and electron back scanning diffraction (EBSD). According to the XRD and Raman analysis, no new phases such as oxides or brittle Al4C3 were detectable in both CNT/Al composite coatings. Some structural damages of CNTs were found in both composite coatings, especially the one fabricated from HSD composite powder. The dispersion of CNTs onto Al particle surfaces by HSD approach did not achieve a significant strengthening effect on the composite coatings, but adversely affected the metallic bonding of the particles and the substrate. The microhardness of the CNT/Al composite coating produced from SSBM powders reached around ~115 HV0.1, showing a significant improvement compared to the pure Al coating mainly due to the grain refinement and CNTs strengthening.

Unraveling the dispersion mechanism of carbon nanotubes in aluminum powder particles during high energy ball milling by FIB-TEM study

Long-term Ball Milling and Hot Pressing of In-Situ Nanoscale Tungsten Carbides Reinforced Copper Composite and Its Characterization

Improving carbon nanotube dispersion in aluminum matrix composite powders by a repeating-deformation ball milling process

Study on the Properties of Carbon Nanotube (CNTs) Reinforced AlSi10Mg Composites Fabricated by Powder Metallurgy

Balanced strength and ductility in CNT/Al composites achieved by flake powder metallurgy via shift-speed ball milling

Evolution of Microstructure and Mechanical Properties of CNTs/Al-Mg Composites Prepared by Powder Metallurgy

Al/CNT nanocomposite fabrication on the different property of raw material using a planetary ball mill

Synthesis of carbon nanotube reinforced Al matrix composite coatings via cold spray deposition

Mechanical milling and its influence on microstructure and electric conductivity of high mass fraction TiC / Cu composites

Towards Homogeneous Distribution of Coarse Grain in a Tri-Modal Al-based Composites Utilizing Localized Grain Growth

Smart Mechanical Powder Processing for Producing Carbon Nanotube Reinforced Aluminum Matrix Composites

CNT-induced heterogeneous matrix grain structure in CNTs/Al composites

Influence of particulate B4C with high weight fraction on microstructure and mechanical behavior of an Al-based metal matrix composite

Effect of powder microstructure on the thermal and mechanical properties of hot extruded Al-CNT composite

Amorphization in the AlC System by Mechanical Alloying

A Powder Metallurgy Route to Fabricate CNT-reinforced Molybdenum-Hafnium-carbon Composites

Nanoscale Dispersion of Carbon Nanotubes in a Metal Matrix to Boost Thermal and Electrical Conductivity via Facile Ball Milling Techniques

Improvement of interfacial interaction and mechanical properties in aluminum matrix composites reinforced with Cu-coated carbon nanotubes

Architectural and component design of CNTs/Al hierarchical composite for enhanced mechanical/thermal properties

Improving the mechanical properties of carbon nanotubes reinforced pure aluminum matrix composites by achieving non-equilibrium interface

Mechanical properties of the Al-Mg/MWCNTs composite powders: The effects of ball milling process parameters