New Prospects on High On-Current and Steep Subthreshold Slope for Innovative Tunnel FET Architectures

C. Diaz Llorente,J-p Colinge,S. Martinie,S. Cristoloveanu,J. Wan,C. Le Royer,G. Ghibaudo,M. Vinet

DOI: https://doi.org/10.1016/j.sse.2019.03.046

IF: 1.916

2019-01-01

Solid-State Electronics

Abstract:We propose three innovative SOI Tunnel FET architectures to solve the recurrent issue of low ION and degraded subthreshold slope measured on TFETs. These are evaluated and compared with a standard TFET structure (with lateral tunneling) using the Sentaurus TCAD tool. Extending the source (anode) at the bottom of the body region generates vertical band-to-band tunneling. Moreover, reducing the vertical distance between the extension and the gate oxide (L-rt) yields a very steep slope and higher ION compared to a device with only lateral tunneling, but only for gate lengths longer than 100 nm. Using an ultrahigh boron dopant concentration (10(21) cm(-3)) thin layer at the bottom for extremely small body thickness (T-Si < 7 nm), increases ION even for small gate lengths (L-G < 100 nm). The implementation of an embedded tip in the source enhances the maximum electric field at the source/channel junction, but the impact on the performance is limited because the tunneling area is not increased. Therefore, this architecture provides a performance similar to a standard TFET. TCAD simulations using SiGe with different germanium concentrations (30% and 50%) and pure germanium, instead of silicon, show an increase of the interband tunneling current when using an ultrahigh dopant concentration thin boron layer for small gate lengths (L-G < 50 nm). The reduction of the tunneling current using a relatively thick channel (11-7 nm) can be compensated by using a higher germanium concentration to reduce the energy bandgap. However, this will increase the density of defects causing a TAT tunneling instead of interband tunneling, jeopardizing the possibility of achieving a subthreshold swing below 60 mV/dec.