Abstract:As an advanced connection technology for large thick-walled components, narrow gap laser welding has the advantages of small heat input and high efficiency and quality. However, porosity defects are prone to occur inside the weld due to the complex welding environment. In this study, the influence of the process parameters and pollutants such as water and oil on the porosity defect were explored. The action mechanism of water on the electron temperature and spectral intensity of the laser-induced plasma was analyzed. The results showed that the spectral intensity during narrow gap laser welding was weaker than that of flat plate butt welding. Under the optimal welding process conditions, the electron temperature during narrow gap laser self-fusion welding was calculated as 7413.3 K by the Boltzmann plot method. The electron density was 5.6714 × 1015 cm−3, conforming to the thermodynamic equilibrium state. With six groups of self-fusion welding parameters, only sporadic porosity defects were observed according to the X-ray detection. When there was water on the base metal surface, a large number of dense pores were observed on the weld surface and in the weld through X-ray inspection. Compared with the spectral data obtained under the normal process, the relative light intensity of the spectrometer in the whole band was reduced. The electron temperature decreased to the range of 6900 to 7200 K, while the electron density increased. The spectrum variation during narrow gap laser wire filling welding was basically the same as that of laser self-fusion welding. The porosity defects caused by water and oil pollutants in the laser welding could be effectively identified based on the intensity of the Fe I spectral lines.

Analysis of Droplet Transfer and Porosity Characteristics in Laser-MAG Hybrid Welding of Edge Joint

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

Mechanism analysis on suppressing porosity in laser-MIG hybrid welding of aluminum alloy via external magnetic field

Droplet transfer characteristics in high-power laser–MAG hybrid welding: Influence of energy parameters

Effects of heat source arrangements on Laser-MAG hybrid welding characteristics and defect formation mechanism of 10CrNi3MoV steel

Droplet detachment and motion behaviors in laser-MIG hybrid welding of aluminum alloy

Effects of heat source configuration on the welding process and joint formation in ultra-high power laser-MAG hybrid welding

Research on weld formation mechanism of laser-MIG arc hybrid welding with butt gap

Investigation on Porosity Suppression in Deep-Penetration Laser Welding by Using Computational Fluid Dynamics

Effect of welding stability on process porosity in laser arc hybrid welding of dissimilar steel

Formation Regularity of Pores During Laser Welding of Die-Cast Magnesium Alloys and Its Mechanism

Mechanism investigation for the influence of laser power on droplet transfer behaviors in laser-MIG hybrid welding

Influencing mechanism of high speed on the droplet transfer and process stability during high-power laser-arc hybrid welding

Simulation Study on Weld Formation in Full Penetration Laser + MIG Hybrid Welding of Copper Alloy

Numerical Analysis of Welding Defects in the Horizontal Position Laser-Metal Inert Gas Hybrid Fillet Welding

Effects of Welding Parameters on Weld Porosity During CO2 Laser Welding of Die-Cast Magnesium Alloys

Numerical simulation on pore formation and suppression for dual-beam laser welding of sandwich structure

Reducing the Porosity in Die-Cast Magnesium Alloys During Laser Welding

Investigation of the Inhibition Mechanism of Process Porosity in Laser-MIG Hybrid-Welded Joints for an Aluminum Alloy

Study on Porosity Defect Detection in Narrow Gap Laser Welding Based on Spectral Diagnosis

Progress and perspectives of joints defects of laser-arc hybrid welding: a review