Abstract:In laser-arc hybrid welding, the appropriate position between the laser beam and arc will be helpful in forming an intensive interaction and significantly increasing penetration depth. In this paper, first, an orthogonal experiment with three factors and four levels were carried out on the inclination angle of the welding torch, the arc length, and the distance between laser beam and TIG electrode, Dla, to find the optimal positional parameters with the strongest laser-arc interaction. The composite plasma behaviors and interaction mechanism between laser and arc were then analyzed under different position parameters; on this basis, the influence of laser power on the laser-arc interaction was further analyzed. Results reveal that the interaction is a decided difference under different positions. When the distance Dla is small, the arc will be significantly compressed; when the laser acts on the arc center, the pre-heating of the arc will greatly improve the laser absorption rate, a shorter arc length will help to further increase the penetration. When the distance Dla, the arc length, and the welding torch angle are 1.5, 1 mm, and 45, respectively, the laser-arc interaction reaches its strongest level and the weld penetration is the deepest. In this case, the arc tail is obviously shortened, and the laser-arc composite plasma volume in the central region is greatly increased. Further, when the laser-power percentage is 10%-50%, the weld profile shows the characteristics of laser heat-conduction welding; when the laser-power percentage is 50%-80%, the weld profile shows the characteristics of laser deep penetration welding; and when the laser-power percentage is 80%-100%, the valid penetration is shallow and accompanied by a large splash due to the very short laser duration. But the weld profile should also be characterized by typical laser deep-penetration welding when the duration of laser action is enough long.

Droplet transfer characteristics in high-power laser–MAG hybrid welding: Influence of energy parameters

Influencing mechanism of high speed on the droplet transfer and process stability during high-power laser-arc hybrid welding

Behavior and Stability of Droplet Transfer under Laser-Mig Hybrid Welding with Synchronized Pulse Modulations

New Insights into the Role of Laser Power in the Droplet Transfer of Laser-Mig Hybrid Welding

Mechanism investigation for the influence of laser power on droplet transfer behaviors in laser-MIG hybrid welding

Droplet detachment and motion behaviors in laser-MIG hybrid welding of aluminum alloy

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

Study on droplet transfer mechanical behavior in laser-MIG hybrid welding process

Research Status of Stability in Dynamic Process of Laser-Arc Hybrid Welding Based on Droplet Transfer Behavior: A Review

Effect of energy parameters on droplet transfer behavior and weld formation in laser-arc hybrid welding with cable-type welding wire

Investigation on droplet transfer behavior during fiber laser-flux cored arc hybrid welding

Behavior of the Plasma Characteristic and Droplet Transfer in CO2 Laser–gmaw-P Hybrid Welding

Effects of Pulse Arc on Droplet Transfer and Spatter of Laser Pulsed-Arc Hybrid Welding

Influence of Distance Between Laser and MIG Arc on Drop Transfer Process of CO_2 Laser-Mig Hybrid Welding

Influence of Laser on the Droplet Behavior in Short-Circuiting, Globular, and Spray Modes of Hybrid Fiber Laser-Mig Welding

Influence of the Laser Thermal Effect on the Droplet Transfer Behavior in Laser-Cmt Welding

Effects of Welding Positions on Droplet Transfer in CO2 Laser–mag Hybrid Welding

Process stability in laser–MIG hybrid welding of aluminum alloys with various laser and arc distances

Characteristics of Droplet Transfer in CO2 Laser-Mig Hybrid Welding with Short-Circuiting Mode

Effect of Relative Position in Low-Power Pulsed-Laser–tungsten-inert-gas Hybrid Welding on Laser-Arc Interaction

Investigation on Surface Forming and Stability of Laser+Pulse Melting Gas Metal Arc Hybrid Welding