Abstract:As an advanced connection technology for large thick-walled components, narrow gap laser welding has the advantages of small heat input and high efficiency and quality. However, porosity defects are prone to occur inside the weld due to the complex welding environment. In this study, the influence of the process parameters and pollutants such as water and oil on the porosity defect were explored. The action mechanism of water on the electron temperature and spectral intensity of the laser-induced plasma was analyzed. The results showed that the spectral intensity during narrow gap laser welding was weaker than that of flat plate butt welding. Under the optimal welding process conditions, the electron temperature during narrow gap laser self-fusion welding was calculated as 7413.3 K by the Boltzmann plot method. The electron density was 5.6714 × 1015 cm−3, conforming to the thermodynamic equilibrium state. With six groups of self-fusion welding parameters, only sporadic porosity defects were observed according to the X-ray detection. When there was water on the base metal surface, a large number of dense pores were observed on the weld surface and in the weld through X-ray inspection. Compared with the spectral data obtained under the normal process, the relative light intensity of the spectrometer in the whole band was reduced. The electron temperature decreased to the range of 6900 to 7200 K, while the electron density increased. The spectrum variation during narrow gap laser wire filling welding was basically the same as that of laser self-fusion welding. The porosity defects caused by water and oil pollutants in the laser welding could be effectively identified based on the intensity of the Fe I spectral lines.

Investigation on Porosity Suppression in Deep-Penetration Laser Welding by Using Computational Fluid Dynamics

Modelling of Keyhole Dynamics and Porosity Formation Considering the Adaptive Keyhole Shape and Three-Phase Coupling During Deep-Penetration Laser Welding

Droplet Transfer Induced Keyhole Fluctuation and Its Influence Regulation on Porosity Rate during Hybrid Laser Arc Welding of Aluminum Alloys

Numerical study of keyhole-induced porosity suppression mechanism in laser welding with beam oscillation

Simulation of the Effect of Keyhole Instability on Porosity during the Deep Penetration Laser Welding Process

Investigation of the Inhibition Mechanism of Process Porosity in Laser-MIG Hybrid-Welded Joints for an Aluminum Alloy

Modeling and numerical study of keyhole-induced porosity formation in laser beam oscillating welding of 5A06 aluminum alloy

Prevention and mechanical analysis of porosity formation in pulsed CO2 laser welding of 30CrMnSiA

Porosity inhibition of aluminum alloy by power-modulated laser welding and mechanism analysis

Study on Porosity Defect Detection in Narrow Gap Laser Welding Based on Spectral Diagnosis

Understanding the Effect of Oxygen on Weld Pool and Keyhole in Laser Beam Welding

Numerical study of keyhole dynamics and porosity formation during high‐power oscillating laser welding of medium‐thick aluminum alloy plates

Numerical simulation on pore formation and suppression for dual-beam laser welding of sandwich structure

Thermal and Fluid Flow Characteristics and their Relationships with Porosity in Laser Welding of AA5083

Effects of Welding Parameters on Weld Porosity During CO2 Laser Welding of Die-Cast Magnesium Alloys

Fluid Flow Characteristics and Porosity Behavior in Full Penetration Laser Welding of a Titanium Alloy

Study on the influence of Al-Si welding wire on porosity sensitivity in laser welding and process optimization

Effect of plate thickness on weld pool dynamics and keyhole-induced porosity formation in laser welding of Al alloy

Investigation of Weld Root Defects in High-Power Full-Penetration Laser Welding of High-Strength Steel

Enhanced Penetration Depth during Reduced Pressure Keyhole-Mode Laser Welding

Repression of porosity with beam weaving laser welding