Effects of Power Modulation, Multipass Remelting and Zr Addition Upon Porosity Defects in Laser Seal Welding of End Plug to Thin-Walled Molybdenum Alloy
Lin-Jie Zhang,Jiang-Zhe Liu,Jun-Yu Pei,Jie Ning,Liang-Liang Zhang,Jian Long,Gui-Feng Zhang,Jian-Xun Zhang,Suck-Joo Na
DOI: https://doi.org/10.1016/j.jmapro.2019.04.001
IF: 5.684
2019-01-01
Journal of Manufacturing Processes
Abstract:Aiming to solve the serious porosity defects in laser welded girth joints of thin-walled tube and end plug made of nano-sized Ce2O3 doped Mo alloy (NC-Mo), the influences of laser power modulation, multipass remelting and zirconium (Zr) addition on the number, size and distribution of porosity defects were experimentally studied. By utilizing X-ray computed tomography (XCT), scanning electron microscope (SEM), energy dispersive spectroscopy (EDS) analysis, transmission electron microscope (TEM) and Raman spectrum (RS), the porosity feature of welded joints achieved under various conditions was analyzed. The results showed that welding cycles had a significant influence on the porosity ratio of fusion zone (FZ) while the amplitude and frequency of laser power waveform slightly influenced the porosity. When the welding cycles increased from 2 to 8, the porosity ratio of FZ decreased from about 1.00% to about 0.48% and the maximum and average pore diameters reduced by about 53% and 27%, respectively. Adding minor Zr in molten pool can further reduce the R-p of FZ to about 0.35%. Through analysis, it can be seen that the pores in FZ can be divided into irregularly-shaped keyhole-induced pores and spherical metallurgy-induced pores. The latter was generated possibly because some impurity elements (including O and H) pre-existing in base metal (BM). Increasing welding cycles can promote the gas in molten pool to float and outflow, thus significantly decreasing the porosity. Moreover, Zr added in molten pool can be preferentially reacted with O to generate ZrO2, which can inhibit the precipitation of volatile MoO2 to thus suppress the generation of metallurgy-induced pores.