Abstract:This study investigates the effects of boron nitride (BN) coating characteristics on the subsurface oxidation behavior of SiC/SiC composites in high‐temperature, water‐rich environments. Three types of coatings were examined: a crystalline stoichiometric BN, an amorphous BN, and a Si‐doped amorphous BN, the latter two containing 5–10 at% of oxygen and carbon. High‐resolution imaging and chemical analysis techniques were used to probe microstructural changes after oxidation at 1000°C for 1 or 12 h in flowing 20 vol% H2O, focusing on effects of coating thickness. Complementary chemical thermodynamic calculations and models for reaction‐ and transport‐controlled recession were used to interpret the experimental findings. Crystalline BN coatings produce open recession channels without forming borosilicate glass, a consequence of carbothermal reduction arising from C/CO produced through concomitant SiC oxidation. The combination of active oxidation and the relatively thick coatings in this system (ca. 1 μm) leads to a recession rate controlled by the intrinsic BN volatilization rate rather than the rate of gas transport. In contrast, amorphous coatings, both undoped and Si‐doped, readily oxidize to form borosilicate glasses that replace the BN. Broadly, the recession lengths increase with coating thickness. In the early stages, while the glass is boria‐rich and thus permeable to environmental oxidants, recession is controlled by the BN oxidation rate. As boria volatilizes, the silica concentration in the glass increases, eventually reaching the saturation limit and precipitating solid silica on the internal surfaces, essentially arresting further recession.

Degradation of Boron Nitride Interfacial Coatings Fabricated by Chemical Vapor Infiltration on SiC Fibers under Ambient Air/room Temperature Conditions

Deposition of BN interphase coatings from B-Trichloroborazine and its effects on the mechanical properties of SiC/SiC composites

The effect of deposition temperature of BN interphase on the tensile properties of SiC fibers

Influence of BN microstructure on oxidation of SiC/BN/SiC composites

Preparation and characterization of boron nitride coatings on carbon fibers from borazine by chemical vapor deposition

Dip-Coating of Boron Nitride Interphase and Its Effects on Mechanical Properties of Sicf/Sic Composites

Degradation mechanisms of a self-healing SiC (f) /BN (i) /[SiC-B 4 C] (m) composite at high temperature under different oxidizing atmospheres

Formation of Boron Nitride Coatings on Silicon Carbide Fibers Using Trimethylborate Vapor

Influence of Dip-Coated Boron Nitride Interphase on Mechanical and Dielectric Properties of SiCf/SiC Composites

Effects of BN Coating on the Oxidation and Crystallization Behavior of Si3N4 Fibers

Microstructure and Mechanical Properties of Si3N4f/BN Composites with BN Interphase Prepared by Chemical Vapor Deposition of Borazine

Influence of BCl3/NH3 flow ratio on growth and microstructure of CVI-processed boron nitride interfacial coatings

Effect of BN/SiC Interfacial Coatings on the Tensile Properties of SiC/SiC Minicomposites Fabricated by PIP

Effect on BN Interphase Thickness Upon SiCnws@BN/HfC Coating Performance under Impact and Ablation Environment

Effects of Dip-Coated Bn Interphase on Mechanical Properties of Sicf/Sic Composites Prepared by Cvi Process

Intermediate temperature degradation of a SiC/BN/SiC (MI) composite with holes at 500–900°C in steam

Microstructure control of BN interface and its effect on mechanical behavior of SiC f /SiC composites

High-temperature Oxidation Behavior of SiBN Fibers in Air

Boron nitride coatings by chemical vapor deposition from borazine

Internal Friction and Torsional Creep Behavior of Chemically Vapor Deposited Boron Nitride

MICROSTRUCTURE OF CHEMICAL VAPOR DEPOSITION SiC-BχC COATINGS IN HIGH TEMPERATURE SIMULATED ENVIRONMENTS