Abstract:In this paper, the design, fabrication, and characterization of a robust and low-power micro-machined two-dimensional (2-D) wind sensor based on a glass-in-silicon reflow process are presented for the first time. The four thermistors, which act simultaneously as heat sources and as temperature sensors, are placed on a low thermal conductivity glass substrate, and arranged in a Wheatstone bridge configuration supplied with constant voltage. In this self-heated mode, the total power consumption of the sensor could be reduced into the sub-milliwatt range, offering high initial sensitivity and wide measurement range, respectively. The embedded vertical silicon vias in the glass substrate are used to realize the electrical connections between the sensing elements and the electrode-pads, which are respectively placed on the front and the back surface of the chip. Then, the sensor and the external circuit are connected using the wire-bonding process through the electrode-pads on the back surface. The bonding wires at the backside is encapsulated by polyester paint, protecting the electrical connections of the sensor from the effect of the external environment. In addition, a passivation layer of nitride is deposited on the surface of the wind sensor to prevent direct exposure of the sensing elements to harsh media. The sensor was tested in a wind tunnel in constant voltage mode. Measurement results show that the thermal wind sensor can measure wind speeds up to 17.5 m/s, and the measured sensitivities of the sensor with different applied voltages (0.5, 1, 1.5 V) are, respectively 24.9, 148.3 and 440.61 mV/(m/s) at zero-flow point. The corresponding power consumption of the sensor with different voltages are respectively 4.81, 19.23 and 43.27 mW. Measurement results also show that wind direction in a full range of 360° with an err within 6° could be obtained. The proposed sensor can be used for many applications with a low power consumption and high reliability.

Configuration of a Self-Heated Double Wheatstone Bridge for 2-D Wind Sensors

Design of wind sensor system based on microcontroller

A Cross-Type Thermal Wind Sensor With Self-Testing Function

A smart 2-D wind sensor with self-test function

Field Measurement System Based on a Wireless Sensor Network for the Wind Load on Spatial Structures: Design, Experimental, and Field Validation

A Novel 2-D Wind Sensor with Thermal Feedback

A 2D Wind Sensor Using the $\Delta$ P Thermal Feedback Control

Full-Bridge Design for Error Reduction of 3-D Printed Mechanical Wind Sensor

Wide span thermal wind sensor system with dual chips

Fabrication and Static Calibration of Double-Layer Thermal Film Sensor for Fluid Wall Shear Stress Measurement

Temperature Effects on the Wind Direction Measurement of 2D Solid Thermal Wind Sensors

A Hot Film Wind Sensor with Four Constant Temperature Difference Elements Fabricated on Ceramic Substrate

Octagon-Shaped 2-D Micromachined Thermal Wind Sensor for High-Accurate Applications

Micro-mechanical two-dimension wind speed and wind direction sensor and signal processing circuit thereof

Design of a 2D Thermal Wind Sensor Based on MEMS Process

Experimental Study of a Dual-Mode Control MEMS Wind Sensor with High Accuracy

Development of A Self-Packaged 2d Mems Thermal Wind Sensor for Low Power Applications

Drie Trenches And Full-Bridges Design For Sensitivity Improvement Of Mems Silicon Thermal Wind Sensor

Modeling, Simulation, and Fabrication of a 2-D Anemometer Based on a Temperature-Balanced Mode

DRIE Trenches and Full-Bridges for Improving Sensitivity of 2-D Micromachined Silicon Thermal Wind Sensor

A Robust and Low-Power 2-D Thermal Wind Sensor Based on a Glass-in-silicon Reflow Process