Abstract:In this paper, the design, fabrication, and characterization of a robust and low-power micro-machined two-dimensional (2-D) wind sensor based on a glass-in-silicon reflow process are presented for the first time. The four thermistors, which act simultaneously as heat sources and as temperature sensors, are placed on a low thermal conductivity glass substrate, and arranged in a Wheatstone bridge configuration supplied with constant voltage. In this self-heated mode, the total power consumption of the sensor could be reduced into the sub-milliwatt range, offering high initial sensitivity and wide measurement range, respectively. The embedded vertical silicon vias in the glass substrate are used to realize the electrical connections between the sensing elements and the electrode-pads, which are respectively placed on the front and the back surface of the chip. Then, the sensor and the external circuit are connected using the wire-bonding process through the electrode-pads on the back surface. The bonding wires at the backside is encapsulated by polyester paint, protecting the electrical connections of the sensor from the effect of the external environment. In addition, a passivation layer of nitride is deposited on the surface of the wind sensor to prevent direct exposure of the sensing elements to harsh media. The sensor was tested in a wind tunnel in constant voltage mode. Measurement results show that the thermal wind sensor can measure wind speeds up to 17.5 m/s, and the measured sensitivities of the sensor with different applied voltages (0.5, 1, 1.5 V) are, respectively 24.9, 148.3 and 440.61 mV/(m/s) at zero-flow point. The corresponding power consumption of the sensor with different voltages are respectively 4.81, 19.23 and 43.27 mW. Measurement results also show that wind direction in a full range of 360° with an err within 6° could be obtained. The proposed sensor can be used for many applications with a low power consumption and high reliability.

Micro-mechanical two-dimension wind speed and wind direction sensor and signal processing circuit thereof

Design and Test of 2-D MEMS Wind Speed and Direction Sensor

A Novel 2-D Wind Sensor with Thermal Feedback

Design of a 2D Thermal Wind Sensor Based on MEMS Process

Design of wind sensor system based on microcontroller

Cross structure two-D wind speed wind direction sensor and preparation method thereof

A smart 2-D wind sensor with self-test function

Wide span thermal wind sensor system with dual chips

Experimental Study of a Dual-Mode Control MEMS Wind Sensor with High Accuracy

A 2D Wind Sensor Using the $\Delta$ P Thermal Feedback Control

A Micro-Wind Sensor Based on Mechanical Drag and Thermal Effects

Development of A Self-Packaged 2d Mems Thermal Wind Sensor for Low Power Applications

An accurate ultrasonic wind speed and direction measuring method by combining time-difference and phase-difference measurement using coded pulses combination

Octagon-Shaped 2-D Micromachined Thermal Wind Sensor for High-Accurate Applications

Design and Test of a Two-dimensional Integrated Flow Sensor by CMOS Technology

A Robust and Low-Power 2-D Thermal Wind Sensor Based on a Glass-in-silicon Reflow Process

High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation

Two Capacitive Micro-Machined Ultrasonic Transducers for Wind Speed Measurement

Flip-Chip on Board Packaging of A Thermal Wind Sensor

COMPACT MEMS THERMAL WIND SENSOR USING DUAL POLYSILICON LAYERS WITH IMPROVED ACCURACY

Micro anemometer by a MEMS compatible lab-on-a-tube technology