Abstract:Piezoelectric wind energy harvesters (PWEHs) offer promises in sustainable green energy supply for micropower electronics. However, traditional PWEHs encounter challenges in terms of high start-up wind speeds, subpar output performance, and narrow bandwidth, hampering their widespread adoption. To enhance the energy capture efficiency, a novel self-adjusting PWEH integrating a centrifugal spring mechanism (CSM) is presented. The CSM consists of a sliding rod, a 304 stainless steel spring, an exciting magnet, and a mass block. Additionally, the PWEH employs a vertical-axis blade design, allowing it to capture wind from different directions. Via theoretical analyses, finite element simulations, and experiments, key parameters of the PWEH are optimized including the CSM additional mass, spring wire diameter, and the configuration of multi-frequency piezoelectric transducers. Results demonstrate that the optimized PWEH works at 1.5 m/s and generates 0.45 mW, 2.742 mW, and 5.973 mW at wind speeds of 2 m/s, 3.3 m/s, and 4.75 m/s, respectively. Compared to the unoptimized PWEH, the introduction of the CSM results in an 80.7 % enhancement in open-circuit voltage and a 90.9 % increase in short-circuit current. Additionally, by utilizing four pairs of piezo-transducers with different resonance frequencies (6.83 Hz, 9.38 Hz, 12.1 Hz, and 14.8 Hz), the resonance bandwidth of the PWEH is expanded to 1.5–5.5 m/s. The feasibility of PWEH for powering signage, electronic screens, and Bluetooth thermohygrometer is demonstrated. The potential of PWEH in constructing high-precision intelligent wind speed monitoring systems is tested via convolutional neural networks. The study offers a strategy for designing the PWEH for both powering of the microelectronic devices, and intelligent sensing and monitoring of wind.

Design and Optimization of Resonant Cavity Piezoelectric Cantilever Sensor for Wind Velocity and Direction Measurement

Simulation and Design of Piezoelectric Microcantilever Chemical Sensors

Design and Optimization of Laminated Piezoresistive Microcantilever Sensors

An accurate ultrasonic wind speed and direction measuring method by combining time-difference and phase-difference measurement using coded pulses combination

High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation

Two Capacitive Micro-Machined Ultrasonic Transducers for Wind Speed Measurement

Novel Rotor Effective Wind Speed Estimation Method for Light Detection and Ranging Application

Resonance-State Temperature Compensation Method for Ultrasonic Resonance Wind Speed and Direction Sensors

Design optimization of flexible piezoelectric PVDF unimorphs for surface pressure transducer applications

Design of Piezoresistive Micro-Cantilever with Stress Concentration Regions

Development of piezoelectric microcantilever flow sensor with wind-driven energy harvesting capability

A Centrifugal Spring Mechanism Empowers Self-Adjusting in Piezoelectric Wind Energy Harvesting

Numerical analysis of effective refractive index ultrasonic sensor based on Cantilever arm structure slot-based dual-micro-ring resonator

Manufacture of Piezoelectric Sensor Dedicated to Airflow Velocity Detection

Modified Coefficient of Equivalent Mass to Explain Decreased Relative Sensitivity of Piezoelectric Cantilever Humidity Sensor in High Mode

Design and Optimization of MEMS Resonant Pressure Sensors with Wide Range and High Sensitivity Based on BP and NSGA-II

Airfoil Anemometer With Integrated Flexible Piezo-Capacitive Pressure Sensor

Multimodal piezoelectric wind energy harvester for aerospace applications

Piezoelectric wind energy harvesting from vortex- induced vibrations of an elastic beam

A BTO/PVDF/PDMS Piezoelectric Tangential and Normal Force Sensor Inspired by a Wind Chime

Design and Optimization of SOI Piezoresistive Microcantilever Sensors for Use in Surface Stress Measurement