Abstract:In view of the serious adhering failure of cemented carbide inserts during the heavy-duty cutting of water chamber head, the adhering failure mechanism of inserts and the element diffusion model of the adhering process were investigated. First, based on cutting simulations, the cutting force was found to be as high as 45.2 kN while the maximum cutting temperature was 930 °C. Under the combined action of mechanical and thermal loads, element diffusion occurred between insert and workpiece and formed an adhering layer, resulting in the adhering failure of inserts. After that, the element diffusion dynamics equation of the adhering process was proposed according to Fick’s law. Based on the semi-infinite long-bar diffusion model and its initial conditions and boundary conditions, the dynamics equation was solved, with the element diffusion concentration model obtained. In the end, the experimental scheme of element diffusion was put forward, and the element diffusion between the cemented carbide insert and workpiece at elevated temperatures was experimentally investigated. The diffusion distance of Co in 508III steel was measured as 8 μm. The element diffusion concentration within the diffusion distance was compared with the value predicted by the model, with the effectiveness of the element diffusion model validated. The concentration distribution of diffusing elements in the diffusion cross section was characterized through experiments and compared with the theoretical concentration distribution. The research results can provide a basis for the in-depth study of the formation mechanism of insert-chip adhering layers and their influence on the cutting performance and service life of inserts.

Tool Life and Wear Mechanism of WC–5TiC–0.5VC–8Co Cemented Carbides Inserts when Machining HT250 Gray Cast Iron

Enhanced the Mechanical Properties and Corrosion Resistance of Ultra-Coarse Grain WC-8Co Cemented Carbides by the Introduction of Cu and Ni

Preparation, properties and microstructure of high hardness WC-co cemented carbide tool materials for ultra-precision machining

Wear-resistant and Anti-adhesive Properties of WC-FeAl Cutting Tool on Dry Machining of Ductile Cast Iron

Enhancing cutting performance of Ti(C,N)‐Based cermet tools on nodular cast iron by incorporating high‐entropy carbide

Influence of cutting parameters on PCD tool wear during milling tungsten carbide

Performance and wear mechanism of spark plasma sintered WC-Based ultrafine cemented carbides tools in dry turning of Ti–6Al–4V

Wear characteristics and micro-cutting damage model of cemented carbide by deep cryogenic treatment

Influences of Micro Mechanical Property and Microstructure on Performance of Machining High Chromium White Cast Iron with Cbn Tools

Effect of In-Situ (ti&w)c Multiphase Particles on Three-Body Abrasive Wear of High Chromium Cast Iron

Ultrafine WC–Co cemented carbide end mills prepared by spark plasma sintering and wear mechanism in milling of AISI H13

Enhanced high temperature mechanical properties of WC-Co cemented carbides by VC addition

Multi-pattern failure modes and wear mechanisms of WC-Co tools in dry turning Ti–6Al–4V

Effect of Substrates Characteristics on Tribological Behaviors of AlTiN-Based Coated WC–Co Cemented Carbides

Microstructural characteristics and wear-resistant mechanisms of WC-TiC-co coatings with varying TiC contents

Investigation on the Performance of Spark Plasma Sintered Ultrafine WC-Co Cemented Carbide End Mills During High-Speed Precision Milling of Ti-6Al-4V Alloy

Interfacial bonding and wear behavior of macroscopic TiC particulates reinforced iron-based composites fabricated by infiltration casting process

Adhering Failure and Optimization of Cemented Carbide Inserts for the Heavy-Duty Cutting of High-Strength Steel Forgings

Tool life assessment of high strength cast iron alloys in dry face milling operations

Microstructure and Wear Resistance of WC and High Chromium Cast Iron Hardfacing Layers

Study on the adhering failure mechanism of cemented carbide inserts and element diffusion model during the heavy-duty cutting of water chamber head