Abstract:By using sol-gel spin coating method nanostructured Pb(Zr0.53Ti0.47)O3(PZT) ferroelectric thin films were fabricated on the Si substrates coated by nanoporous alumina membranes with average pore sizes of 20-100nm,in which metal(Au or Pt)nanowires were embedded as a part of the bottom electrode.The dielectric,ferroelectric properties and microstructure of the nanostructured PZT thin films were characterized.The dielectric measurements demonstrated that the dielectric constant of the PZT nanofilms with a thickness of 25nm decreased quickly from 860 to 100 as increasing the frequency below 104 Hz,and then remained almost constant of 100 as further increasing the frequency up to 106 Hz.Such a fast decrease of the dielectric constant in the low frequency region was resulted from the dielectric relaxation of space charges accumulated at the interfaces between the nanofilm and the(bottom and top)metal electrodes.The dielectric loss peak observed near 4000Hz was contributed from the resonant absorption effect of the space charges.The polarization-electric field hystere-sis loops of the nanostructured PZT films with a thickness 100nm showed that the remanent polarization of the PZT nanofilm was 50μC/cm2 and coercive field of 500kV/cm.Cross-sectional TEM images showed that the nanostructured PZT films contacted directly with the bottom electrode(metal nanowires),and the interface between them exhibited some degree of waviness.It was found that some Au nanowires became into branches at their ends after post-annealing the PZT nanofilms,whereas such a phenomenon was effectively prohibited by using Pt nanowires.A selection of proper post-annealing temperature was the critical processing parameter for fabricating nanostructured PZT ferroelectric thin films as making a trade-off between the ordered metal nanowires within the nanoporous alumina membranes and the crystallinity of ferroelectric nanofilms.

Fabrication of PZT Nanotubes in Through-Hole PAA Template Using Sol-Gel Spin Coating Method

Preparation of PZT Thick Film by a High Speed Sol-gel Method

Fabrication and Characterization of Size-Controlled Single-Crystal-like PZT Nanofibers by Sol–gel Based Electrospinning

Fabrication of Nanostructured PZT Ferroelectric Thin Films and Their Characterization

Fabrication of PZT microdevices using a high-yield sol-gel process

Two Stage Formation of Silver Nanoparticles in PZT Thin Films Controlled by Re-Nucleation Through Transition Phase of Ag-Pb Alloy

Exploration of single-crystal like electrospun Pb(Zr_(0.52)Ti_(0.48))O_3 nanofibers synthesis via electrospinning

Fabrication of (100) Orientated PZT Thin Films for MEMS Applications

Fabrication of the Carbon Nanotubes with Small Pits or Embedded by Nanoparticles Via Template-Assisted Method

ZnO nanotubes by template-assisted sol–gel route

Poly(vinyl Pyrrolidone)-Assisted Hydrothermal Synthesis of Pb(Zr0.52Ti0.48)O3 Nanocrystals

Fabrication and Piezoresponse of Electrospun Ultra-Fine Pb(Zr0.3, Ti0.7)O3 Nanofibers

Pva Assisted Synthesis of Nanosized Perovskite Pzt Powder by A Two-Stage Precipitation Route

Growth and Characterization of Lead Zirconate Titanate (PZT) Thin Films

Shape-controlled synthesis of lead zirconate titanate nanocrystallites, microrods, microrolls and 3D complex architectures via the effects of poly-vinylalcohol macromolecular conformation

Processing and characterization of lead zirconate titanate nanopowders by a simple water-based sol-gel method

Processing of PZT Microstructures

Synthesis and characterization of nanocrystalline PZT powders by a simple sol-gel method

Template-based Synthesis and Micro-structure Characterization of TiO2 Nano-array

Zinc Aluminate Nanotubes Fabrication Based on Heating-Induced Volatilization and Kirkendall Effect in Nanopores of Anodic Aluminum Oxide Template

Biotemplated synthesis of PZT nanowires.