Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Key Techniques for Erection of Steel Truss Girders of Dashengguan Changjiang River Bridge in Nanjing

Design and Construction of 4200 kN Cable Crane for Caiyuanba Changjiang River Bridge

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Innovative Technology in Channel Bridge Foundation Design and Construction of Pingtan Strait Hi-Rail Bridge

Design of Trestle of Pingtan Straits Rail-cum-Road Bridge

Replacement Construction of Gusset Plates at Adjustable Stringers for Rail-cum-Road Steel Truss Girder Bridge

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Ultimate Bearing Capacity of Steel U-Girders under Local Load in Incremental Launching Method

Safety Control Research of Steel U Girder of Composite Bridge with Incremental Launching Construction

Evaluation of Long Multi-Span Steel U-Shaped Girder During Incremental Launching Construction

Deck Derrick Crane,Lifting and Erection of Steel Box Girder Blocks of the 3rd Nanjing Changjiang River Bridge

Pursuit for Industrialized Construction of Nanjing Jiangxinzhou Yangtze River Bridge

A Construction Technique of Incremental Launching for a Continuous Steel Truss Girder Bridge with Suspension Cable Stiffening Chords

Incremental Launching Construction of a Long Span Bridge with Continuous Steel Truss Girder and Flexible Arch

Design and key construction technology of steel-concrete-steel sandwich composite pylon for a large span cable-stayed bridge

Key Construction Technology of HuSuTong Yangtze River Bridge

Construction technology innovation of Sunk Shaft foundation and composite tower of 1200m highway and railway cable-stayed bridge

STUDY ON THE FULL SCALE SEGMENTAL MODEL OF TOWER OF CABLE STAYED BRIDGE OF THE SECOND YANGTZE RIVER BRIDGE IN NANJING

Closure Construction Monitoring Technology of the Super Long-span Steel Tied-arch Truss Bridge

Construction Survey Control of Incrementally Launched 8×50-m Span Curved Girders of Donghai Bridge Close to Island Side

Simplified Method of Erection Monitoring for Continuous Concrete Box Girder