Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Integral Lifting of a Three-Span Continuous Beam Bridge

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Design and Construction of 4200 kN Cable Crane for Caiyuanba Changjiang River Bridge

Jacking Technology for a Simply Supported Girder Bridge

Integral lifting project of the Qifeng bridge

Integral Lifting Construction and Monitoring of Qifeng Bridge in Huzhou City

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Safety Control Research of Steel U Girder of Composite Bridge with Incremental Launching Construction

Design and Dynamical Analysis of New Light Deployable Bridge

Evaluation of Long Multi-Span Steel U-Shaped Girder During Incremental Launching Construction

Simulation analysis and control research of long multi-span composite bridge with incremental launching construction

Static and Dynamic Behavior of Continuous Box Girder Bridge and Its Experimental Investigation

Model Test on Incremental Launching Construction Method for JIUBAO Bridge in Hangzhou

A Construction Technique of Incremental Launching for a Continuous Steel Truss Girder Bridge with Suspension Cable Stiffening Chords

Reinforcement Analysis of an Old Multi-Beam Box Girder Based on a New Embedded Steel Plate (ESP) Strengthening Method

Asymmetric Cantilever Construction Control of a U-Shaped Box Concrete Continuous Bridge in Complex Environment

4D Full-Scale Finite Element Analysis in Bridge Engineering

Key Construction Technology and Monitoring of Long-Span Steel Box Tied Arch Bridge

Incremental Launching Construction of a Long Span Bridge with Continuous Steel Truss Girder and Flexible Arch

Finite Element Modeling and Calibration of a Three-Span Continuous Suspension Bridge Based on Loop Adjustment and Temperature Correction

Stress and deformation analysis of the steel pipe arch integral lifting construction process of a continuous beam arch bridge