Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Construction Survey Control of Incrementally Launched 8×50-m Span Curved Girders of Donghai Bridge Close to Island Side

Structural design and analysis of a large span partially single-sided cable-stayed pedestrian bridge

Key Techniques for Erection of Steel Truss Girders of Dashengguan Changjiang River Bridge in Nanjing

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Safety Control Research of Steel U Girder of Composite Bridge with Incremental Launching Construction

Evaluation of Long Multi-Span Steel U-Shaped Girder During Incremental Launching Construction

Simulation analysis and control research of long multi-span composite bridge with incremental launching construction

Ultimate Bearing Capacity of Steel U-Girders under Local Load in Incremental Launching Method

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Construction and Construction Monitoring Techniques for Thin-Walled V-Shape Piers

Analysis of the forces in the construction of large-span steel box girder by incremental construction

Study of construction control for Heigou Super-large Bridge in Inner Mongolia

A Construction Technique of Incremental Launching for a Continuous Steel Truss Girder Bridge with Suspension Cable Stiffening Chords

Monitoring and Control for Large Span Cable-stayed Bridge

Asymmetric Cantilever Construction Control of a U-Shaped Box Concrete Continuous Bridge in Complex Environment

Integral Lifting of a Three-Span Continuous Beam Bridge

Walking-Type Bidirectional Incremental Launching and Mid-Span Closure Technology for Steel Box Girders with Long Cantilevers

Research on the construction control technology of large span cable-stayed bridge tower and girder

Incremental Launching Construction of a Long Span Bridge with Continuous Steel Truss Girder and Flexible Arch

Replacement Construction of Gusset Plates at Adjustable Stringers for Rail-cum-Road Steel Truss Girder Bridge

Coordinate Monitoring Technology in the Process of Incremental Launching Construction of Curved Steel Box Girder Bridge